Electronics Forum | Mon Feb 18 09:46:42 EST 2019 | cdav1100
We currently run a Yes Tech BX machine using the Yes Vision software on Windows 7. With Windows 7 support running out in January next year, I was curious if anyone had managed to run the Yes Vision software under Windows 10. The obvious answer is to
Electronics Forum | Wed Jul 31 14:08:22 EDT 2002 | Dave G
Used this paste on ENIG boards W/O N2 and had very good results. (0402's,BGA's,16mil FP) Never had the need to use N2 with this paste on our products. Running with N2 shouldn't hurt anything. The wetting properties should get even better than they ar
Electronics Forum | Tue Aug 05 12:05:20 EDT 2003 | dougt
It looks like I could setup a UPS on this machine one of two ways. The first would be a 3 phase, 208V UPS in series with the machine (sounds big and expensive). The second is a single phase 208V UPS to just the 2 computers. I have a safety concern
Electronics Forum | Sun May 31 11:14:48 EDT 2015 | visionbot
Looks good. Have you done any work on feeding > form part tubes? I have a back burner project > trying to speed up the changover on our machine > with the vibe feeders. VisionBot works with cut tape SMT, is not necessary to have advanced mechani
Electronics Forum | Mon Jul 13 06:30:59 EDT 2009 | hcarrasco
1.- Check your vacuum a.- Check filters b.- Check air flow (the vacuum is generated by a Ventury using air flow, not air pressure) c.- Vaccum vias (Possible linth inside the vacuum lines) 2.- Check the nozzle condition (Probably broken o
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Mon Jun 17 15:04:08 EDT 2002 | genny
I think I had my units wrong in my previous post - that blueprint job was 6 years ago and fading fast. My level of 700 would have the same units as Dave's level of 1000. This is the metric measurement of lux, vs the imperial footcandles. fc to lux
Electronics Forum | Sat Jun 07 13:46:43 EDT 2014 | ipdisplays
Hi All, I know that is thread hasn't seen activity in a year or so... I'm having a similar issue in configuring a line. I see that the IEC addr is called version in the real.ma file. This is not helping me since I apparently have two machines that
Electronics Forum | Sun May 31 11:19:19 EDT 2015 | visionbot
Good luck Alexandru. I went through this years > ago and it is a lot of fun. For the next 5-6 > years you will learn a lot about P&P systems, as > you will get your feedback from your > customers(trust me it is going to be a lot and > you will
Electronics Forum | Tue Jul 18 06:59:02 EDT 2017 | cyber_wolf
Sergey, I understand your thought process kinda, but you are not going to justify yourself a pick and place line based on a "simple" 5K board contract unless you know something we don't. You do not want a machine that has buggy or slow software. Any
