Electronics Forum | Mon Feb 16 07:11:25 EST 2004 | paul_bmc
Does anyone know how often the optical sensor goes bad on the CS-400E machines. I have 2 machines and it seems that the optical correction does not work anymore. I keep getting an optical correction error, when the mode is turned on the correction
Electronics Forum | Thu Dec 19 08:26:19 EST 2013 | dekhead
Are both machines running the same type of computer (Advantech Computer w/P3 1G CPU probable)? if not possible problem with system software incompatibility. Contact me directly, I may be able to assist. www.dekhead.com
Electronics Forum | Tue Dec 27 09:39:36 EST 2016 | westshoredesign
Thank you for the reply, MPMEng. I received the Speedline UPG-026/27, but it actually came with the incorrect mouse. Since original post I've contacted seller, received correct mouse, successfully installed drivers, encountered a new issue. At thi
Electronics Forum | Tue Aug 04 13:45:56 EDT 2009 | pauld
Unable to access older Forum threads. "Internal Server Error The server encountered an internal error or misconfiguration and was unable to complete your request. Please contact the server administrator, root@localhost and inform them of the time t
Electronics Forum | Fri Jul 16 17:49:06 EDT 1999 | JohnW
| | Hello, | | i'm looking for informations about companies which are using system to verify the loadind of a SMT machine by using barcode (on the slot on the machine & on the reel). | | I'm in charge of the installation of this kind of system. | |
Electronics Forum | Mon Feb 02 16:30:46 EST 2004 | paul_bmc
I have one machine that I am having trouble getting the machine to recognize an offset. I keep getting the error, "When correcting Offset 1: Invalid offset, press 'esc". Does anyone know what I am doing wrong. On another machine I have I keep havi
Electronics Forum | Wed Mar 24 11:28:45 EST 2004 | Mika
Hi, Why don't You contact Universal GSM tech specialists on this one? Just pick up the phone and explain Your problem and they will help you: Customer Support Center 1-800-842-9732 or 607-779-5000. There is also tech documents on their web site tha
Electronics Forum | Mon Nov 10 16:43:24 EST 2008 | markgray
Steve, I finally played with it enough that it is working again. I ended up with Edge Threshold: 19; Intensity Threshold: 60; Offset: 200; Gain: 16 The problem seemed to be with the Intensity Threshold. I was not getting an error code on the screen
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Sat Feb 11 02:50:07 EST 2023 | dekhead
Please contact me directly; DEKHEAD@ATT.NET
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400