Electronics Forum | Tue Oct 22 17:23:35 EDT 2002 | Yannick
Hi, I wondering if someone know the anwser to that. I'm using a solder paste 63/37 and on the solder joint we have a tiny little layer or flux who is like crystalin. I try to play with my profile the get it off but I don't get much success. So D
Electronics Forum | Mon Nov 11 15:41:55 EST 2002 | ikovnatsky
hi, Does anyone have a set of install disks for an mcs16f I called fuji and they do not have any ( they sent the last ones out 4 weeks ago) I have two corrupt files on my HD tci and tran_p. Any help or suggestions will be apreciated. Ilya
Electronics Forum | Thu Mar 18 11:17:58 EST 2004 | jdumont
So I finally got it running. It ended up being a combination of bad card and corrupt file in the \falcon directory. Luckily I had lots of help from Bob Tomaselli at Magellan Services. Does anyone know where I could find a schematic for these boards?
Electronics Forum | Fri Sep 16 16:37:31 EDT 2005 | Randy
HI! Does anybody know driller/miller called > "Direct Imaging System II"? I have one, but its > not working properly. I think that there is some > corruption in software. All kinds of information > about this machine is welcome: manuals, software
Electronics Forum | Wed May 09 11:59:50 EDT 2012 | aemtexas
Our Panasonic KME Create CM95R-M pick and place machine was in storage for a long time and the system battery died, so now the static RAM is corrupted. We need to obtain a "key" floppy to reflash the static RAM. Thank you in advance for any advice an
Electronics Forum | Thu Aug 16 11:15:38 EDT 2012 | menatech
delete the pointer readings.dek. If the printer loads after restart is the problem a corrupt program (last printed product. if this not work could it be a problem with the DEK config file. save the the file on floppy and delete it from the m/c. the s
Electronics Forum | Mon Jul 29 19:17:27 EDT 2013 | peteralmendrala
Hi Guys! I hope you could help me with my problem. I am currently repairing our speedline mpm spm printer, its software has been corrupted. Does anyone here be able to provide me the installer for the said machine. Our backup installer from floppy di
Electronics Forum | Thu Aug 29 14:41:10 EDT 2013 | kdc45
We found we had a bad communication cable which caused all of the files to be corrupted. We then held the RESET down while powering up and it successfully dumped. We were then able to send status, proper and programs to the machines. Hope this helps
Electronics Forum | Wed Dec 04 16:35:54 EST 2013 | martingruber
I am facing the following problem: Powering up the machine the start sequence stops with following message: Inizializing Hardware .... Reading SRAM data .... Inizializing MEI Motion Bd .... Mei bd. @ 240 # Dev. Version 2.4g2 Option 41 DSP BOOT MEMORY
Electronics Forum | Wed Dec 18 22:41:36 EST 2013 | dekhead
You don't say what software version is running on machine; generally caused by corrupted file; delete E: config local.lpf file and then reboot machine (new file will be created). If not this, recommend reload of machine software (should not require s
