Electronics Forum | Fri Sep 26 07:43:55 EDT 2008 | mysmt
Hello aj, 5V & 12 V checked & present.
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Sun Mar 07 21:26:54 EST 1999 | Chris G.
| My printer evaluation has come down to the Fuji GP-6 or the Dek 265LT. I'm looking for experienced opinions on both of these options, we're currently running an older vintage Dek 265 printer that gives us constant electronic system problems. The v
Electronics Forum | Wed Mar 10 10:11:10 EST 1999 | Justin Medernach
| | My printer evaluation has come down to the Fuji GP-6 or the Dek 265LT. I'm looking for experienced opinions on both of these options, we're currently running an older vintage Dek 265 printer that gives us constant electronic system problems. The
Electronics Forum | Tue Jul 30 12:30:21 EDT 2013 | JB
We are breaking a 1995 Dek 265GS screen printer for spares, it has the blue under screen cleaner, green 2D inspection camera. Was in full working order before getting a new Dek printer installed. The reason for replacing it was the air line pipes had
Electronics Forum | Fri Sep 26 12:26:16 EDT 2008 | dwelch123
Isn't that what I just said? Read it again. I said you can swap zero and one OR two and three.
Electronics Forum | Mon Jul 30 17:31:59 EDT 2018 | dekhead
That error message is keyed by a hardware (soldered) link on the backplane board of the Y1 (motor controls), through direct cable to PCIB40#3... check connections both ehds; possibility of multiple PCIB failures?
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Fri Sep 26 12:16:52 EDT 2008 | bickt
you cannot swap 0-3 only 0-1 or 2-3 they are not the same euro cards. they function very diffrently. if you look you will see there are more chips and circuitry on one set. there are 2 w/red leds and 2 with green leds. at least thats how they soo
Electronics Forum | Sat Sep 16 15:47:08 EDT 2006 | dekhead
95% possibility to the ballscrew... which is no ones favorite to replace. As far as the table situation now. I'm guessing that you have verified that the motor has power and the brake is not engaged. Does it still give a position error? or does it g