Electronics Forum | Fri Dec 07 13:38:06 EST 2007 | ehess
Does anyone kbnow where I can find replacement belts for the old PCT (Process control Technologies) conveyors?
Electronics Forum | Fri Dec 07 14:44:35 EST 2007 | actech
I have ordered 3/16th and 1/4 from McMaster Carr in the past. you buy it bulk cut it at an angle and melt it together. I think its Mcmastercarr.com and look into belts or conveyor belting you should be able to find it online there.
Electronics Forum | Wed Dec 12 10:40:08 EST 2007 | ehess
Thanks Bruce. This method is working good for me, for now anyway. I'll have to see how good my splices hold up over time.
Electronics Forum | Fri Dec 14 11:27:57 EST 2007 | floydf
I have had luck with New England Belting: http://www.newenglandbelting.com/ Good Luck
Electronics Forum | Thu Dec 13 10:30:42 EST 2007 | slthomas
I would never have guessed that McM-Carr would carry that stuff (antistatic belts) but you learn something new every day....thanks! Question, though. Their online catalog says to order by the inch of circumference (OC, or outer circle), implying tha
Electronics Forum | Wed Jan 08 19:16:56 EST 2020 | spoiltforchoice
http://suddendocs.samtec.com/literature/em_tectalk8a_lr.pdf Even so its still a fairly manual process so I guess you really have to want to use this type of connector because its a whole process in itself and I bet the whole family is a special or
Electronics Forum | Thu Mar 20 16:53:32 EDT 2008 | guhansub
Min spacing will be 0.75'' on all the 4 edges
Electronics Forum | Wed Mar 19 09:54:44 EDT 2008 | davef
Here's what we suggest: * Keep a 5-mm space between a board edge and a ceramic capacitor. * Mount the capacitor parallel relative to the edge. * Design pads about a half of the termination. * Fixture the board when using your pizza cutter.
Electronics Forum | Sat Nov 05 20:23:11 EDT 2016 | sarason
Close but not to close, would have to be the spec. Or depends on your separating technology. Prerouted boards on a panel, you could go right up to the edge. V-grove you will need more distance, maybe 2mm's or more. The distance from the panel edge to
Electronics Forum | Tue Mar 18 12:38:39 EDT 2008 | fsw
Hi! Can anyone tell me what is the min spacing between PCB edge & land pattern to avoid cracking of components due to mechanical stresses caused while depaneling with cookie/pizza cutter. Thnx!
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400