Electronics Forum | Mon Jul 05 15:35:45 EDT 2004 | adlsmt
Topaz $30K to $45K depending on feeders and hours. I bought a 1997 with 8000 hours, 100 feeders, an AP-20 Screen printer and two nice conceptronics ovens for $50K about 6 months ago. I would think the Emerald would go for less because they are slow a
Electronics Forum | Thu Feb 14 13:06:54 EST 2019 | compit
What is the best way to introduce a choke like from a drawing? Emerald often misunderstands the number of pins - pads have an irregular shape. Also with the lifting is a problem - for the nozzle 63 is too heavy and rotates when moving, the nozzle 64
Electronics Forum | Wed Nov 20 11:54:43 EST 2019 | compit
I'm trying to make a spare disk for an SMT machine. I format the new PCMCIA card with the system (using the machine's DOS, 6.20) but when the computer starts it writes that I don't have a system. How I make a floppy disk in this way - it starts from
Electronics Forum | Tue Aug 17 09:49:59 EDT 1999 | Earl Moon
| Looking for users of the Emerald pick and place.Comments on that equipment would be greatly appreciated. QFP and micro-BGA placement, idiot proff software etc. | | We just got a good offer to use that equipment for our training center instead of o
Electronics Forum | Tue Nov 17 07:37:19 EST 2015 | micropak
Hello I got a SiPlace 80-S20 machine which had a damaged hard drive in MC. I changed HDD and re-installed RMOS + MC from floppies. Then I turned on the machine (without any Line Computer). The software on Station computer wouldn't go past the "Soft
Electronics Forum | Mon Dec 29 16:49:57 EST 2014 | emanuel
Hi Rob, I am writing this reply as an update. Unfortunately I got your recommendation a bit too late, I contacted Count-On Tools and ordered from them a custom made nozzle for the Emerald. $300 paid for the "pleasure", everything could be OK if it w
Electronics Forum | Sat Nov 21 07:57:48 EST 2015 | micropak
Actually I from the SC I am able to ping both the MC and the LC. By switching the monitor display the MC shows text the last line of which says"Config completed enabling task". The ICOS display is a red cross hair. All the axis cards show green LEDS.
Electronics Forum | Mon Oct 15 14:29:58 EDT 2018 | compit
I have an Emerald X machine (by Assembleon) with an LCS. I start production. The first PCB board runs to the end of the LCS (item 1). Each subsequent stop is BEFORE LCS (item 2) - I have to remove it manually. And so until the production reset - then
Electronics Forum | Wed Apr 29 09:27:49 EDT 2020 | zombee
Dear friends, We have a pack of Philips/Assembleon pick and place machines, from CSM and GEM series. I want to set up a "new" Emerald machine, it had been working in Germany 1.5 year ago. It has 3-phase connector. I noticed that it was set
Electronics Forum | Thu Aug 26 20:35:33 EDT 2021 | kumarb
Hi. Have the Emerald-X (Yamaha YV88X) unit. Works fine. Using F9 (Teach & Trace), we can position to most locations on the front feeders (not to the extreme left or extreme right due to the head design). Should the unit be able to do the same for t