Electronics Forum | Fri May 28 15:01:02 EDT 1999 | Tony
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Wed Aug 23 17:43:42 EDT 2023 | calebcsmt
Support bars, so essentially the board is sitting ontop of beams that make a table. Fully supported with no soft spots
Electronics Forum | Mon Aug 12 18:26:05 EDT 2002 | pjc
If you are talking actual placement rate- from first fiducial read of board no. 1 to first fiducial read of board no. 2, here is the best I've ever seen based on the boards I've run: CP3- 141 seconds for 468 components per board (all rectangular chi
Electronics Forum | Fri Dec 17 09:04:17 EST 2010 | wolverine
We have an older model CP40-LV that will start out the day with blurry and double vision, then after about twenty minutes of just idling, the vision slowly improved until the machine could find the board fiducials and do a passable placement job. Th
Electronics Forum | Thu Aug 11 07:41:55 EDT 2005 | rsmith@z-mar.com
I do recommend dedicated tips and dedicated workstations. Make sure that your tips come in with no lead in the tinning. There is a new, green heat resistant table mat that is being used in the industry to identify lead free areas. If operators see gr
Electronics Forum | Tue Dec 05 15:10:55 EST 2000 | Francois Monette
Victor, here are a few more elements of information to answer your question. Both the temperature and relative humidity on the manufacturing floor have a significant impact relative to the rate of diffusion of moisture inside a plastic package and t
Electronics Forum | Sat Apr 20 10:12:16 EDT 2002 | davef
If people use an inert gas, they use nitrogen for mass soldering. Inert gases get progressively more expensive as you move down the periodic table. Many times no-clean flux is less active than other flux types. So, people use an inert gas to lower
Electronics Forum | Wed Nov 29 08:25:28 EST 2006 | aj
Hi, I work mainly with Fujis but have some experience with Panas. If you are seeing components upside down on the board it is feeder related . If you are seeing poor alignment across the board , firstly I would check the xy table for alignment. Mak
Electronics Forum | Fri May 28 16:03:10 EDT 1999 | Jeff Sanchez
| Has anyone had experience with prototype-scale, table top Placemax and/or Manncorp pick and place equipment? If so, what has been your experience with the machines? Are they reliable? Did they meet all your needs? Which needs didn't they fill?
Electronics Forum | Thu Mar 10 09:13:15 EST 2005 | davef
From http://www.IPC.org ... IPC-7351 - Generic Requirements for Surface Mount Land Pattern and Design Standard The successor to the IPC-SM-782A is here! The document covers land pattern design for all types of passive and active components, includ