Electronics Forum | Fri Jun 04 10:29:42 EDT 2004 | gregf912
Check ATS at WWW.ATS-SMT.Com for support on any Fuji and MPM machine in the US.
Electronics Forum | Thu Jul 11 17:26:27 EDT 2002 | Tony B
Does anyone know how the Fuji IP2 can be adapted to place BGA's? The MTU places the chip on a carrier with suction in the center and it will not hold on to the BGA due to the lack of a flat surface on the bottom. I have had limited success building
Electronics Forum | Fri Jul 12 12:04:51 EDT 2002 | jax
The Lizard Tongue is just a thin metal strip that, when actuated, slides over the BGA component and holds it down during transport. If you contact FUJI, they should be able to give you a part number, and install instructions..... maybe even the real
Electronics Forum | Fri Jul 12 12:30:56 EDT 2002 | soupatech
I just go off the phone w/ Fuji and they seem to think that the lizard tounge (used another name, same idea) is only available for the IP3. They had a few other suggestions for adapting the IP2 like a rubber pad for the carrier or building "rails" to
Electronics Forum | Thu May 06 05:34:02 EDT 2004 | Grant Petty
Hi, We are looking at a new pick and place machine that can handle higher throughput. What do people think of the smaller Fuji machines. They look like they have some nice features and are fast. I saw someone's note on Panasonic and reliability. W
Electronics Forum | Fri May 07 07:02:52 EDT 2004 | rlackey
Hi Grant, We use the CP series from Fuji - so not quite the same, but the quality of engineering and company philosophy will almost certainly carry over into the XP range. Our machines are totally bombproof reliability wise, and the programming i
Electronics Forum | Sat May 08 18:44:55 EDT 2004 | Grant Petty
Hi, That's an interesting point to consider, and I will check Phillips get more info. The Fuji machines do have some nice ideas in them, however they are a bit untested here, and no one I know is operating one, so that's why I hope someone is online
Electronics Forum | Tue May 11 20:49:39 EDT 2004 | alwil
Hi Grant, a few things you should also consider are, do you have a local agent for the piece of kit you are about to purchase. Are spares and consumables readily available in your area. Can you and your staff receive inhouse training or have
Electronics Forum | Tue May 18 21:53:05 EDT 2004 | Grant Petty
Hi, I have been checking into the Universal machine, and it also looks good. I am now trying to work out what the advantages and disadvantages are between the Universal or Fuji machines are. It's hard to decide. Does anyone have experiences with bo
Electronics Forum | Mon Jan 09 18:51:05 EST 2006 | grantp
Hi, I have used both MYDATA TP9, MY9 and more recently MY12. MYDATA machines are just not accurate, and we did everything possible, and every kind of upgrade they had. We ended up putting in Fuji XP based machines, and the differences are very notic
