Electronics Forum | Tue Apr 10 11:14:57 EDT 2007 | Scotceltic
I agree. We use Bartector. It is a very cost-effective solution to do what you need. It can hook up to all Fuji equipment including the new NXT.
Electronics Forum | Thu Apr 12 02:57:25 EDT 2007 | poultorp
you might wanna look at the Valor (Trace Expert) program they support also the old Fuji's but it might be a "over kill" in this case http://www.valor.com/en/Products/Manufacturing%20Execution.aspx
Electronics Forum | Wed Oct 15 15:47:35 EDT 2008 | mbrunton
Thank you Dana and Stephen, I will give it a shot now. I'm not surprised it's not in the manual... apparently there is tons of stuff not in the manual and Fuji tells me they have no idea what half of the unwritten stuff means :)
Electronics Forum | Tue Mar 27 14:08:12 EDT 2007 | diesel_1t
Nobody??? Regards.
Electronics Forum | Wed Apr 11 18:46:06 EDT 2007 | darby
Excellent reply. You have my sympathies. Good luck!
Electronics Forum | Wed Apr 11 19:06:59 EDT 2007 | diesel_1t
Seems to be easy and effective, I will ask for further information with them... Regards
Electronics Forum | Tue Apr 03 20:55:36 EDT 2007 | rob_thomas
Manuel, Try http://www.bartector.com/. I consult at a company in my hometown and they have this in place and works very well with their old and new Fuji equipment. I doubt that it costs 100K. I have no ideea how much it is but I think is worth che
Electronics Forum | Tue Apr 03 00:37:51 EDT 2007 | grantp
Hi, I think the only solution would be to contact Fuji and ask if there is an interface to the machine to write software for it. I read somewhere that FujiTrax allows a IT system type connection which software could be written for. Another solution
Electronics Forum | Fri Oct 17 20:26:21 EDT 2008 | diesel_1t
If is IP-1, is using SMD2 vision instead of SMD3 (CPIV-IP3, CP6,7, etc) if so, you must use Vision Number instead of Vision type... if you're using fuji flexa just press F1 on vision number and you will se most common vision numbers depending on shap
Electronics Forum | Sat Mar 24 12:31:31 EDT 2007 | diesel_1t
Hi there. Ok, i have a little big question for fuji Erudites: when machine run out of parts on any device it tells to machine "parts out (and part number)" So, a signal from anywhere (maybe a PLC output) will tell to the machine "hey i'm out of parts