Electronics Forum | Tue Jul 13 10:51:55 EDT 2010 | muarty
Sounds pretty much like the sensors/amplifiers need tuned on your machine. It is a fairly straightforward exercise to do this. The sensors basically look at the back of the chucks to determine which nozzle is in the lowest position and therefore whic
Electronics Forum | Tue Jul 13 21:05:04 EDT 2010 | dman97
Thanks for the replies. Indeed the amplifier needed to be tuned. I have recalibrated it and all is working as it should. Thanks for the advice.
Electronics Forum | Wed Apr 16 16:58:00 EDT 2014 | jimmyboz
My first guess, loose wire or bad cable. Email me and I will send you a checklist.
Electronics Forum | Mon Jun 29 08:50:55 EDT 2015 | tdemon69
looking for some one that works on these machine for a living, that my company can higher from time to time to do some work on them.
Electronics Forum | Mon Jun 29 09:23:59 EDT 2015 | tnisbet
We service MPM machines. Tom Nisbet tom@goppm.com 603 765-8814 www.goppm.com
Electronics Forum | Mon Aug 29 11:39:23 EDT 2016 | tdemon69
I was wondering if you could help me with my Panasonic MV. it is throwing parts around after it picks them up . only have 3 heads work in it.
Electronics Forum | Mon Aug 29 13:34:58 EDT 2016 | mhanrahan
We had this issue with our old MV 150. This was usually due to clogged/dirty or bent nozzles, or clogged dirty filters on the vacuum supply to the head.
Electronics Forum | Tue Jul 02 10:37:36 EDT 2019 | dman97
I also forgot to add that if the proper data was not generated by flexa for the CP6, then flexa will not communicate with the machine. You need to flush the proper and resend using flexa for the communications to work correcty. Good luck!
Electronics Forum | Fri Jul 19 11:16:21 EDT 2019 | dman97
And yes if the proper data is not correct it will give you a error message because Flexa cannot communicate with the CP6.
Electronics Forum | Fri Dec 08 18:02:21 EST 2023 | jdengler
Not sure on CP6's but CP2 through CP4 series used jigs. We now have an AIMEXIII and it uses jigs. I would bet that there are jigs for the CP6 series machines.
