Electronics Forum | Mon Jan 21 11:28:28 EST 2013 | dhopps
The machine will have to be reset-started to wipe the current proper and status out of the machine before you can communicate with an MCS. This can be dangerous if you do not have a current paper copy or disk back-up of your proper because you will
Electronics Forum | Tue Apr 10 02:40:55 EDT 2018 | rob
Hi Stephen, All good machines. Regarding placement speeds ignore what the manufacturers claim, it's utter crap. Start with the IPC9850 number (not perfect, but we have been known to hit it), but even better to make them demonstrate on one of your
Electronics Forum | Thu Oct 30 21:06:20 EDT 2008 | ashley
Hello mickd, For Fuji practice, the primary tooling hole preferably be 5mm from the edge of the PCB (lower right hand corner). This is the reference X0, Y0 co-ordinates in the Fuji program where placing co-ordinates going LEFT will be -ve value & go
Electronics Forum | Wed Apr 03 13:32:30 EST 2002 | Bob
Hi, Just to ease your mind a little. I have 15 years experiance on Fuji kit, and was the engineer in charge of over 30 CP6's. They are very robust and the electrical / electronic side is pretty bomb proof. The main thing to look out for is wear in
Electronics Forum | Thu Jun 10 15:01:24 EDT 1999 | Earl Moon
CP4-3 AND IP3 | >CP4-3 AND IP2 | >CP4-3 AND IP3 | >CP4-3 AND IP2 | >CP3 AND IP2 | >CP3 AND IP2 | Question: | Looking for anyone who has this type of mix, equipment and what is your OEE and how do you come up with the numbers. | | I use Unicam Line m
Electronics Forum | Sat Jan 20 23:48:55 EST 2007 | bvdb
Hi Al, Thanks for the suggestion. Yes, I should have said that the cable has been checked and another cable tested with the same results. In addition to the three wires that carry the transmit data, the receive data and the data signal ground, the
Electronics Forum | Tue Feb 16 16:25:18 EST 1999 | Tuffty
| We use both F4G and MCS at the present and we are phasing out MCS. One main reason is that it's platform is not Y2K compliant. F4G is cumbersome and taxes a high overhead on your computer system. We have also found a bug recently when we have hi
Electronics Forum | Sat Sep 25 09:38:41 EDT 1999 | Steve E ( Fuji America )
| What is the command string used to download updated software | from floppy discs to the mcs16b controller? | Well Eric it depends on what your doing. If your just updating the MCS software, start out at the first screen ( UCI screen ) Go to System
Electronics Forum | Tue Sep 28 13:58:16 EDT 1999 | Eric Lee Williams
| | What is the command string used to download updated software | | from floppy discs to the mcs16b controller? | | | Well Eric it depends on what your doing. If your just updating | the MCS software, start out at the first screen ( UCI screen ) |
Electronics Forum | Fri Jul 19 11:09:29 EDT 2019 | BigFuji642
Yes we have the hard copy of the proper data on a floppy disc. If we do not have the correct Proper Data, could it give me the error below? I was thinking it would make it past the log onto machine comm server stage, and then have a different err