Electronics Forum | Wed Sep 23 23:10:26 EDT 2015 | richardcs
Does any one have calibration jigs for a DEK265 LT, a full manual with schematic would be good as well?
Electronics Forum | Thu Sep 19 11:14:45 EDT 2002 | Jim M.
We had lots of problems with bridging on 15.8mm pitch, QFP17-160 at the start.The board was .032 thick, double sided-six boards to a panel. Here is the problems (not neccessarily in the biggest to little but as i remember them) and solutions that he
Electronics Forum | Tue Jan 24 10:39:45 EST 2006 | O.K.
Hello everybody ! I am looking for manuals or catalogs for different makes of feeders - fuji, siemens, gsm. does anybody know where to find it ? thanks in advance, any replies will be appreciated.
Electronics Forum | Tue Jan 24 21:48:22 EST 2006 | bigdaddysoy9
Universal has GSM feeder manuals in .PDF format on their website. http://www.uic.com/ You have to register to view them.
Electronics Forum | Tue Aug 14 07:58:16 EDT 2007 | dilogic
It HEAVILY depends on the block revision and installed software. Read the serial number of the machine and post it here as well as the software version number... - Dejan
Electronics Forum | Thu Aug 16 04:55:06 EDT 2007 | escalador
Hi: The serial number of the machine is:4681A09051-6-45955404. I dont know the soft version as I did not connect it yet because I am looking for a 3 phase transformer with 230V output for mains. Thanks
Electronics Forum | Tue Aug 21 09:01:14 EDT 2007 | escalador
Hi Mika: It would be great to know the specs required for the transformer as I have a trasformer manufacturer here able to do it. I saw that the machine uses 3 phase without Neutral (230V each)30 amps. These 30 Amps are total or each phase? Regards
Electronics Forum | Thu Apr 09 18:26:47 EDT 2009 | thenrz
Thank you very much for your response. The screenshot did me wonders! This will work wonders for throughput.
Electronics Forum | Thu Jun 18 16:24:10 EDT 2020 | dilogic
Yes, to calibrate you need calibration plate and calibration "parts". There's something you can try, though. There is a setting for on-head camera position. You can modify these values (write down original values, of course) manually and then try it
Electronics Forum | Fri Jul 24 15:23:38 EDT 2020 | ilavu
Why don't you try to manual trimming. If I remember, you have option to trim by camera or by head. This is only for FlexJet (7-Spindle)head.