Electronics Forum | Tue Dec 23 13:53:06 EST 2014 | jimmyboz
Hi all, > > i have installed an CP643E and when i > put power ON,instantly i have the red led HALT > goes ON on the cpu board (HIMV-134) i have > change the board but same problem... do you have > an idea of the problem? > > thanks > > Ben H
Electronics Forum | Tue May 08 13:36:34 EDT 2018 | kdexter0928
I have sent you a dropbox link with all of the manuals that I have. Hopefully this can be of some help. I am also using an MPM accuflex and have troubleshot multiple issues. Feel free to email me with any questions you may have and I can attempt to h
Electronics Forum | Sat Mar 13 13:34:45 EST 2021 | proy
I have an excellent operating X-Ray - Phoenix PCB analyser 160. It seems there was available software for Voiding Calculation but I am not sure if my machine has this - I do know that we have the BGA analysis tool, but have to look in and see if we
Electronics Forum | Fri May 26 13:16:53 EDT 2000 | Todd
I have worked with MPM and GSP (fuji) and the DEK. I have had the least problems with the DEK. Kept having software issues with the MPM although I have heard some having good experiences. We used the GSP for the through hole but needed new vaccum
Electronics Forum | Fri Apr 28 13:23:22 EDT 2000 | Chris McDonald
We have had nsome new products come in that require Bottom side wave soldering (SMT). I have SOIC's 1206, 0805 that are Glued then Wave soldered. I have had trouble with bridging and no-clean residue with these pcbs. I have a Econopak 2 SMT two zone
Electronics Forum | Thu Jul 20 16:23:08 EDT 2000 | Bob Willis
We set up and ran this process at Nepcon UK with some success but we used a UV adhesive less than 10sec cure so no heat. Push off force for the biggest parts was over 800 grams. We have had to modify the design rules a little to make it work but it
Electronics Forum | Thu Nov 12 10:05:05 EST 1998 | Doug Clement
| | I have a need to dispense a latex masking material using an automated dispensing system. We are presently looking at the I&J750. Does anyone have any experience with this piece of equipment, or have a better solution available? | | | Doug: Fi
Electronics Forum | Wed Jan 09 08:36:13 EST 2002 | marquesj
For Pick & Place machines you have Siemens Machines, visit - http://www.siplace.com They are good machines and they have a nice support For loader and unloader you have Nutek visit, - http://www.nutekholdings.com/A5581E/hpage.nsf/Main!OpenFrameSet
Electronics Forum | Wed Jan 23 17:14:33 EST 2002 | Shawn
We have seen solder joints that have an orange peel or textured appearance to them after running over our wave solder machine. We thought it may be disturbed solder joints but it does not have the lines or appearance that a disturbed joint usually sh
Electronics Forum | Tue Jan 31 11:57:40 EST 2006 | aj
i would agree with taking a closer look at the fiducials. I have the same line config. here but have to say that I have never experienced any conflict between machines. One thing I have seen before is when we ran a particular product on the machine
