Electronics Forum | Tue Sep 14 13:49:14 EDT 1999 | Earl Moon
| I am looking to find a formula to calculate the resistance of circuit traces based on width | The old MIL-STD-275 became IPC-STD-275 became IPC-2221/2222. Anyway, they had/have simple graphic representations converting AWG standards into equivalen
Electronics Forum | Thu Jan 03 20:40:23 EST 2002 | Eliud Rivera
The actual water soluble process is killing us. We sent the cloose loop tanks for regenaration each two weeks. We spent too much money sending the tank overseas. Is there a company in PR that recycles this tanks. Maybe in Florida? What is the low
Electronics Forum | Tue Dec 14 13:26:19 EST 2004 | Peter
I have a question regarding post cured property of SMT adhesive. If after component placement, the epoxy dot gets compressed and bridges between the 2 pads, what would the impact on the circuitry? Would it pose risk for flux entrapment? Could the cu
Electronics Forum | Thu Jun 09 10:41:30 EDT 2005 | HOSS
Can anyone recommend a flex/rigid-flex supplier stateside that can do the following: Build to IPC class III (not necessarily certify) Multi-layer Controlled Impedance 2-4 week turn without price premium Take less than 1 week to quote Any info appre
Electronics Forum | Tue Aug 08 17:15:16 EDT 2006 | Ron
That's exactly what I thought but needed a second opinion. I found a part that matches the size, dimensions and two coil but am unsure which impedance it would be. http://www.bourns.com/pdfs/pm0805cm_pm1206cm.pdf Thanks for your input!
Electronics Forum | Wed Oct 10 13:59:49 EDT 2007 | petep
I have always understood that on boards (or circuits) operating over 900 MHz, No Clean fluxes are to be avoided. Apparently the residues left behind, while non-conductive and non-corrosive, will change impedence of the circuit. It may be a possibil
Electronics Forum | Sun Nov 04 01:04:04 EST 2007 | omidjuve
we are manufacturing some rf boards that works on a high frequency margins now our boards doesn't pass in impedance test and we concluded that the problem might cause by the solder paste that we are using . our solder alloy is sn62/pb36/ag2 and we t
Electronics Forum | Fri Nov 20 14:50:13 EST 2009 | davef
One of our instruments has a high impedance front-end. We: * Passed functional test in the environmentally controlled shop. * Failed test, on the same unit, while carrying it to burn-in chambers in an uncontrolled part of the plant. Solder flux resi
Electronics Forum | Fri Mar 19 13:18:03 EDT 2010 | deanm
Regarding your question about buying equipment to vacuum seal the MBBs, according to the IPC/JEDEC standard, "Full air evacuation is not needed or recommended; light air evacuation will reduce the packaging bulk and enhance carton packing. Excessive
Electronics Forum | Tue Dec 02 06:07:00 EST 2014 | sarason
A trick I used to use doing RF design was to have on the edge of a panel, a stripline that I could hook up to a Network Analyser to check board impedance. You could do this to verify if the fault is in the no wash process or a board manufacture proce
