Electronics Forum | Thu Jul 05 09:43:32 EDT 2012 | duso02
What is the specific make/model of the SR? Being in an aerosol, I'm sure they thin it down quite a bit so that thinner is what is attacking your ink.
Electronics Forum | Mon Aug 08 00:53:58 EDT 2016 | hshorakaei
Can we use SMD Machines for printing inks on flexible PCB? (There is a FPC with four layer printed ink) I attached a picture of my board.
Electronics Forum | Tue Jun 06 21:15:23 EDT 2017 | davef
I'd be surprised if you find a non-destructive method of removing carbon ink. Your best bet is following the recommendations of your ink supplier.
Electronics Forum | Tue Apr 06 12:13:46 EDT 2021 | luca
Hello, does anyone know if there is an IPC standard for carbon ink? we use for keypads instead ENIG, we found batchs of PCB with 2-3ohm, 20ohm, until 300ohm( resistance of contact surface) by the same PCB supplier!
Electronics Forum | Fri Dec 14 10:59:23 EST 2001 | Donald C. Burr
We are considering converting from a water wash wave solder porcess of carbon ink touch pad buttons to a no-clean process. Since the carbon ink buttons are exposed to the molten solder, we are concerned about the residue that is left behind from the
Electronics Forum | Fri Jun 27 22:33:16 EDT 2003 | Ben
HI, I'm doing a dye penetrant and peel test of non-function BGA solder joints to locate the fracture surface. After applying dye, I found the dye ink just accumulate at the solder mask edge and spread everywhere after I peeled off the package. THis i
Electronics Forum | Tue May 02 20:55:10 EDT 2006 | Board House
Hi all, I'm looking for anyone with info in regards to reliability of carbon ink vs. Immersion Gold Key pads. I have customers that still request Carbon Ink for there Key pads, while the majority have switch to Immersion Gold. Is there any readin
Electronics Forum | Mon Jul 03 14:47:35 EDT 2000 | Ashok Dhawan
In a typical flowline assembly of circuit boards, what are the different methods used for tracking WIP ? I can think of : 1. travel cards - not suitable for panelised boards 2. Marking ID# on board at various operations while board is being built.
Electronics Forum | Tue Sep 28 17:23:21 EDT 2004 | davef
We use "0" ohm resistors a links. Is that what you're talking about?
Electronics Forum | Fri Oct 28 14:05:44 EDT 2005 | SuMoTe
Have you tried 'Ink-stamping" them?