Electronics Forum | Tue Sep 26 16:22:17 EDT 2006 | russ
What exactly do you require in this kit? Most PCB repair I am aware of is traces/pads and epoxy, neither of which contains lead. Please explain what you need in rohs compliance? Russ
Electronics Forum | Thu May 08 18:02:29 EDT 2008 | jwolvans
Russ, Take a look here: http://www.geigercounters.com/Monitor4.htm You can buy one already assembled, or buy the kit and build it yourself. I've built two of these kits, they work just fine.
Electronics Forum | Thu Dec 17 09:34:05 EST 2009 | pfifla1
does anyone know of a place to purchase a kit to repair or make replacement belts for PCB conveyors? it would be convenient to make vs. repair. they are just the standard rubber conveyor belts.
Electronics Forum | Thu Feb 14 09:13:28 EST 2013 | leemeyer
You will need to purchase a VGA kit for your MVS100 board. Call PPM if they don't have one let me know I have a spare kit That I would consider selling.
Electronics Forum | Mon Aug 28 06:46:22 EDT 2017 | chhrisedwards
PCB Connector Kits: PCB connector kits generally come with both sides of the connector, along with other hardware required to hook the connector up to a PCB. These provide a convenient way to order the parts required to complete a project.
Electronics Forum | Tue Oct 02 09:24:21 EDT 2018 | bandjwet
This one is a cost-effective kit that has real ground planes. http://www.soldertools.net/learning-how-to-solder-training-kit/ Bob
Electronics Forum | Wed Sep 09 20:07:41 EDT 1998 | Dave F
| I am attempting to locate a kit to be used on surface mount equipment to determine the placement capability (CPk). Does anyone have information on where to purchase such a kit? Ideally this kit should be usable on placement equipment from various
Electronics Forum | Wed Sep 09 08:28:04 EDT 1998 | Stefan W.
| I am attempting to locate a kit to be used on surface mount equipment to determine the placement capability (CPk). Does anyone have information on where to purchase such a kit? Ideally this kit should be usable on placement equipment from various
Electronics Forum | Wed Feb 02 16:29:43 EST 2011 | remullis
I can explain our kitting process which was heavily software managed. For our Chipshooters we grouped setups of the optimum algorithym for less carriage movement, and grouping part numbers as much as possible. This was done with some high dollar sof
Electronics Forum | Wed Apr 16 14:40:17 EDT 2008 | jdengler
Peter, We have 2 Fuji lines. We run from 5 to 5000 piece lots. When we are running near capacity and have a lot of change-overs scheduled we have special operators that will load parts onto feeders and organize the feeders like they will be on the
Electronic manufacturing services - electronic design, development and manufacturing. Circuit board design, prototyping, FPGA services, signal integrity and simulation, pcb assembly. Factories in California USA and Malaysia.
Manufacturer / Consultant / Service Provider
3240 Scott Blvd
Santa Clara, CA USA
Phone: +1 408 980 0400
