Electronics Forum | Sat Apr 28 02:20:43 EDT 2007 | basem
Grant-Thanks for letting me know that MyData is made in non-U.S. made machine. Cal-Thanks, I will be sending you an email to your email account you have provided. I have contact MIMOT already, however, they are VERY expensive machines and it will no
Electronics Forum | Wed Feb 01 13:46:05 EST 2006 | Chunks
Sounds like a epididymis! It depends on your paste chemistry. You can't just slap any old saponifier in there. Most water based cleaners evaporate the water and you have to remove the dried paste. It's a bit messy, maybe that's why your's is over
Electronics Forum | Fri Jan 23 10:39:35 EST 2004 | patrickbruneel
Kris, I assume with voids you mean acceptable solder coverage of pad and lead. As Dave mentioned I also have not seen any specific studies on voids, but workman ship standards exist about acceptable coverage of pad and lead (both consumer and MIL)
Electronics Forum | Tue May 11 01:18:35 EDT 2004 | fastek
Grant- Just so happens I was offered an almost new one today. Check them out and if a CP7 is indeed what you decide to get let me know and I'll likely be able to save you some money off of new. Rick fastek@comcast.net
Electronics Forum | Mon Mar 06 21:58:56 EST 2006 | kent_peterson
Good machine! Just like most part libarys don't let the operators change part profiles. Haven't seen it place 0201's but 0402's have no problem. Tape splicing for the feeders is a problem. The eject wheel gets jammed with anything other than splice t
Electronics Forum | Tue Jan 16 07:51:19 EST 2007 | realchunks
Your Quality Manager won't let you make changes, yet you get blammed for process problems? First, you need a change in management. Second, if you can't change set pre-heat temps, change the conveyor speed. Slow it down and see if your joints loo
Electronics Forum | Fri Feb 23 08:28:11 EST 2007 | James
I just wanted to know if anyone stores their vacuum sealed bags on their sides instead of flat. We are trying to save room, but I dont want to create defects either. The ones we have are tightly vacuum sealed and would like to store on their sides
Electronics Forum | Mon Aug 04 09:30:16 EDT 2008 | grics
If you have concerns, you can look at the datasheet for each component or contact one of their application or materials engineers and find out what the components are rated for...process-wise. IE, how long can I be in the oven with this part, at what
Electronics Forum | Fri Oct 15 19:11:14 EDT 2004 | grayman
Hi, This discussion is really getting long. Fuji and other high speed mounter is great and better than small flexible mounter when it comes to speed.But, I rather suggest a modular mounter specially for subcon companies. Let say we combined 2 or 3 m
Electronics Forum | Tue Mar 25 13:55:05 EDT 2014 | horchak
Ok lets put it this way. If the PCB house used a high quality mask and properly applied it to a properly cleaned surface and properly cured it, then as Dave stated above there are only two things that can destroy it. Excessive heat and overly aggress
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437
