Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Mon Nov 04 15:13:51 EST 2013 | sfeinsp
I have two MV-3's and MV-7 machines, love them, easy to use and programm, but not ecspect any machine to catch 100% of defects
Electronics Forum | Sat Feb 12 14:27:22 EST 2022 | micropak
Hope you might have found the manual. But just in case you didn't, I have the English manual for MV-3/MV-7
Electronics Forum | Thu Dec 18 14:54:28 EST 2008 | hegemon
We evaluated OMRON, YesTech and Mirtec. Mirtec and Yestech close at #1 and #2. Omron was a little more distant due to programming time required. We are a high volume high mix OEM builder, so speed of programming was a heavier weighted score than co
Electronics Forum | Wed Jan 26 17:29:55 EST 2011 | eadthem
So Ive talked to mirtec and there going to get us some info on getting a pre release to fix the issues we have had. ATM our current tooling works ok for most things, but when they look in to another mv3, Ile mention that it might be nice having some
Electronics Forum | Fri Jun 01 08:02:40 EDT 2012 | mlevesque
Hello everyone! We check for a new AOI system. I know a Mirtec machine (MV-2HTL), but this time we check for the MV-2GT or MV-3L. I got a presentation about the Aleader AOI and it seems to be good machine. Anyone know somethings about it? What a
Electronics Forum | Wed Jan 19 12:54:17 EST 2011 | bdamico
Hello Mark, The centroid data you are currently using to program the MV-2HTL may be used with either platform. However, the libraries cannot be shared due differences in camera resolution. The MV-2HTL will have a 1.3 megapixel camera versus the 2 m
Electronics Forum | Fri Nov 06 07:46:33 EST 2015 | clampron
Good Morning RedChilli, I have worked with Mirtec for quite a few years. I have looked at some of the other machines mentioned but have no practical experience with them. I started with the Mirtec MV-2 (long ago)due to the success of this platform,
Electronics Forum | Fri Jan 28 14:58:00 EST 2011 | hegemon
When reviewing the defects, I believe you can select the part, right click on it, and select "create new frame". This would create a new frame with that part alone in it, and centered. Better inspection for that part. Possibly this won't work with
Electronics Forum | Thu Feb 28 11:02:31 EST 2013 | hegemon
1. Read the manual. It's pretty good, and an easy read. Most tech guys could read the manual and have a good start. 2. Call Mirtec, they should connect you with a local rep. who may or may not have some machine knowledge. They may want $ if the m