Electronics Forum | Fri Sep 20 15:44:00 EDT 2002 | pjc
Do you have a Panasonic & Toshiba camera? What are the MPM p/ns your looking at? Whats the problem? Noise perhaps. If noise try checking the metal cylinder to the right of the camara housing. The set screws can loosen up. Tighten up all the screws.
Electronics Forum | Tue Jul 05 05:23:34 EDT 2005 | kentes
We have one set MPM AP25. Its prestop position is not stable,but stop position is stable. It often occur "time out" alarm when load PCB.Which one can help us.
Electronics Forum | Mon Oct 31 03:35:41 EST 2005 | pavel_murtishev
Good day, I simply switched the production from MPM to other printing machine. Defect disappeared. Process parameters and process materials were the same. Stencil was the same. �Dog hides� somewhere in the machine. BR, Pavel
Electronics Forum | Mon Mar 05 15:24:41 EST 2007 | Hussman
Well, there you have it Pavel, Tim says to switch to DEK. Start packing up your MPM.
Electronics Forum | Mon Mar 05 22:55:05 EST 2007 | valuems
they cost 35 or 36 hundred dollars from mpm. And if the board are thiner then 20 thousands in thickness, lots of luck.
Electronics Forum | Fri May 04 11:53:41 EDT 2007 | chrisgriffin
Sorry to post here, but I really need two Environmental Control Units for an MPM AP-25. Does anyone have 1 or 2 they can sell me, or know anyone that does.? Thanks
Electronics Forum | Mon Sep 25 13:06:30 EDT 2006 | cyber_wolf
Dax.. Please post when you find the problem. I am very interested to see the outcome. I still stand behind what I posted earlier. My opinion is that you are digging too deep. But...I do realize there are always exceptions....
Electronics Forum | Tue Sep 22 11:25:40 EDT 2009 | jorge_quijano
I'm not pretty sure if this is what you need, It is for a UP2000, hope this helps. JQ
Electronics Forum | Fri Aug 03 11:09:23 EDT 2001 | Eric123
I have paste left on my stencil on the forward stroke. I adjusted the downstop pressure but it didn't help. Any suggestions.
Electronics Forum | Tue Sep 24 08:47:17 EDT 2002 | pjc
Please send me the s/n of your machine to my mail box and I'll see what I can dig up for you.