Electronics Forum | Sat Feb 13 07:57:42 EST 1999 | Kelly
| I am fairly new to the SMT game and I am getting conflicting answers to the following. Maybe someone can help me! When printing, one person is telling me that the stencil should be wiped completely clean of all paste because the quality of the
Electronics Forum | Thu Apr 15 16:13:13 EDT 2004 | pjc
Best recommendation is to compare the two machines with your boards and stencils. Either vendor should be able to arrange for a �test drive� at one of their demonstration facilities or at a local friendly customer. I�m afraid that your request for �o
Electronics Forum | Tue Jun 01 18:06:36 EDT 2004 | Rob
I used an Ultraprint 2000 so if that's what you use then maybe I might be able to help. First, I'm assuming that you've already passed the Teach New Board section. This is board dimension, X and Y boardstop, stencil/squeegee heights and strokes. If
Electronics Forum | Sun May 29 21:44:20 EDT 2005 | KEN
This from a person named "just my thoughts"? As far as "cheaper in the long run" , that can be debatable. Especially at $160 dollars per hour for a FSE. Double rate for weekends. Air fare, hotel, car and per-diem....it adds up fast! Also, he may
Electronics Forum | Thu Jun 23 15:28:48 EDT 2005 | geb
Yeah it says "board model not found", occasionally it will say "Stencil model not found" or something very similar. Do you have the exact same machine? It only shows a small live video image in the bottom of the screen (about 4cm sq.), I cant remembe
Electronics Forum | Sat Sep 30 10:04:39 EDT 2006 | daxman
I found this pot, and tried adjusting it. It was already turned to its maximum, and the histogram did not look good. I tried replacing the board lamp and this helped the histogram a lot, but I am not able to get the bars centered in the green. The
Electronics Forum | Fri Aug 03 14:55:26 EDT 2012 | davef
Not the best situation in the world, but you know that. Check with printer equipment suppliers [eg, DEK, MPM, etc] for a product called "Stencil Clean Wipes." Back in the old days, we'd: * Wipe the stencil with a solvent soaked wipe * Put the sten
Electronics Forum | Tue Nov 29 11:45:35 EST 2016 | ttheis
I was able to repair the original power supply for the printer again with parts from another similar power supply on ebay. At first the machine didn't power up properly even though the supply voltages were all good on a volt meter when tested befor
Electronics Forum | Tue Dec 27 09:39:36 EST 2016 | westshoredesign
Thank you for the reply, MPMEng. I received the Speedline UPG-026/27, but it actually came with the incorrect mouse. Since original post I've contacted seller, received correct mouse, successfully installed drivers, encountered a new issue. At thi
Electronics Forum | Tue Sep 26 15:12:36 EDT 2023 | proceng1
I see that you basically closed the issue, but I'll just say that if you are using OFFSETS to get stencil alignment, your set up is wrong. Unless you KNOW that the board house added the fiducial incorrectly or something, you should be able to get go
