Electronics Forum | Thu Mar 05 07:40:55 EST 2020 | tomdegas
I swapped the mi boards with ones from a working My12 machine and the same results. To recap my problem: On "Hardware Initialization" the center jaws open and close, the Hydra Theta belt moves back and forth, the Hydra head moves all the way down an
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Tue Apr 05 11:03:13 EDT 2005 | cyber_wolf
There are several things that can cause these errors. It sounds as if you have 2 problems. A (Z) problem and a theta problem. 1. Check that the Z-locks are functioning properly in the service program. Make sure that when they are un-locked they don'
Electronics Forum | Mon Aug 24 16:58:05 EDT 2009 | rgduval
Jack, Well, there's always doing it locally on the machine. There's also an old excel macro floating around that will help...it takes the x,y,theta information, and generates a pick and place program. However, we never had much luck with it here
Electronics Forum | Mon Nov 04 15:34:26 EST 2002 | pjc
An effective method to compare the two machines is to go to each vendor's nearest demo facility. Go there with PWBs, components and board data. Find out from each vendor what the minimum board data they'll need- like X-Y Centroid, Theta and Reference
Electronics Forum | Tue Jul 10 11:36:22 EDT 2007 | dyoungquist
Hi SMT Frog We are using an upgraded Mydata TP9-1 system to place 0402s. We do an electrical test plus mechanical centering and use the C14 tool. A few things we have observed/learned: 1) Is the machine not picking the part up out of the tape? Po