Electronics Forum | Mon Mar 07 06:51:31 EST 2011 | mosborne1
Tim you can do your image repeat after you place the whole panel with nozzle #1. In your sequence step program place all with nozzle 1. You can then change to nozzle#2 then place the whole panel with nozzle number 2. This will be one nozzle change. I
Electronics Forum | Wed Aug 29 06:47:59 EDT 2012 | tommyttr
This is a pretty common problem believe it or not. First thing is to bolt down the garages, second is recalibrate them nozzle changer to ensure that head has the right alignment with the changer. If that doesn't work, you can do what I did and just u
Electronics Forum | Wed Jun 11 08:53:53 EDT 2014 | fredcalkins
That would be easy to check. Degaus the whole nozzle not just the tip. It should take more than a week to become magnetized again. If it becomes magnetic sooner maybe degauss the head? I would also make sure your vacuum does not come on till the noz
Electronics Forum | Mon Nov 10 08:53:23 EST 2014 | jpal
We have the opportunity to buy a new selective solder machine and are used to using a very old Jade machine with a moving tank and wetted nozzle. I have two process concept questions: Which is better- move the board over the nozzle or move the nozz
Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Tue Apr 19 10:09:33 EDT 2016 | swag
Try a nozzle changer teach. Machine will look for fids on the changer block. If that doesn't work, clean the rubber seals in the bottom of the block. No alcohol - dries them out. Might need to replace them if they are dry or cracked. Clean your
Electronics Forum | Fri Aug 05 16:42:12 EDT 2016 | jdengler
When the clutch engages the nozzle correctly does it clear the engagement sensor at the end of the brake arm? I don't remember the actual name of this sensor but it clears when the drive gear properly engages the nozzle. This ensures a zero setting
Electronics Forum | Wed May 02 13:02:14 EDT 2018 | emeto
Based on the pickup surface area: 1. Use the biggest nozzle possible, 2.Keep in mind that some nozzles have bigger inside diameter hole(more vacuum) 3. Keep in mind that some pickup surfaces are rigid(not really flat surface) - use rubber tip nozzles
Electronics Forum | Sat Mar 11 07:33:52 EST 2023 | klauss
There's two kind of nozzles with different dimensions we use. One of them works good but the another one gives a head problem sometimes. The head picks the nozzle and gives the vacuum error despite the camera recognize it. So i make another head pi
Electronics Forum | Sun Jul 08 06:38:41 EDT 2007 | dilogic
We have an old GSM1 (I-block, USOS V1.4.14, two 4-spindle heads, changers between rails). When I configure machine so there are no nozzles on heads and changers are filled with required nozzles, except for one empty hole, machine won't pick up nozzle
