Electronics Forum | Mon Jul 27 17:09:20 EDT 1998 | Rin
| We are trying to reduce the number of units fail at system test due to flux on gold finger. We know so far that the flux is deposited onto the | goldfinger during touch-up or rework and to reduce the contamination we are | planning to imp
Electronics Forum | Sun Jul 26 22:35:55 EDT 1998 | D.Lange
Masdi, Try board shunts. They are hi-temp rubber strips with grooves cut. They can be popped on and off with ease and are much faster than taping and considerably cheaper. They also work great for masking goldfingers prior to wave soldering. Contac
Electronics Forum | Tue Aug 18 12:02:59 EDT 1998 | zambri
| Hi, | Need some advice on how to eliminate or reduce the solder on finger that we are having right now. So far what we understand is that 90% of the problem is due to the reflow process where solder traps in vias causing explosion when subj
Electronics Forum | Mon Jul 27 21:10:10 EDT 1998 | D.Lange
| Hi, | Need some advice on how to eliminate or reduce the solder on finger that we are having right now. So far what we understand is that 90% of the problem is due to the reflow process where solder traps in vias causing explosion when subj
Electronics Forum | Tue Jul 28 02:28:48 EDT 1998 | Bob Willis
The causes for solder on gold are: Paste wash offs Dirty stencils Dirty under stencil cleaning cloths/no solvent Poor handling The most common reason is wash offs when there is a couple of balls left on the tabs and they reflow. With correct profile
Electronics Forum | Fri Oct 05 18:59:53 EDT 2001 | Dan Steffler
I have had an issue where solder has contaminated gold plated pads (fingers) where it is not acceptable. The pads must remain perfectly coplaniar for a LCD zebra strip to lay accross them. Does anyone know of a way to remove the marriage level of s
Electronics Forum | Thu Oct 07 20:34:48 EDT 1999 | Tony Huang
Hi, Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! Thanks, Tony
Electronics Forum | Fri Oct 08 17:12:31 EDT 1999 | Dave F
| Hi, | | Does anybody know what is the minimum gold plating thickness on the PCB goldfinger required by the industrial specifications - IPC, Bellcore, etc. Where can I find the information? Appreciate for the help! | | Thanks, | Tony | Hi Tony:
Electronics Forum | Fri Mar 13 17:09:49 EDT 2009 | kmorris
We have found very small solder deposits on the gold fingers of some PCI boards after assembly at our CM. In the IPC-A-610, it says that no contamination or solder is allowed in the critical contact area. 1. I'm looking for feedback on what others
Electronics Forum | Sat Mar 14 09:12:59 EDT 2009 | davef
First, there is no good justification for getting solder on gold fingers. Second, it is well known that solder on gold fingers is unacceptable. So, shipping boards with that condition indicates sloppy quality practices at your CM. Third, that being
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411