Electronics Forum | Sun Oct 30 12:39:13 EDT 2016 | mekmat544
Thank you for your answer, but I am litte bit confusing. There are parameters of V-scoring but with put values. How can I get values for V-scoring for pcb 1,6mm thickenss. Thank you. M.
Electronics Forum | Sat Jun 25 15:20:03 EDT 2016 | skipper6567
I have a mini/micro transformer that is mounted on a pcb inside my lowrance gps/plotter. I have removed it from the pcb. It has 5 through hole pins, 3 pins out bottom one side and 2 pins out bottom on opposite side. The transformer has yellow tape ar
Electronics Forum | Sun Jun 26 08:34:18 EDT 2016 | davef
My guess: http://www.gcitechnologies.com/
Electronics Forum | Sun Oct 09 16:57:30 EDT 2016 | davef
IPC 2222A Sectional Design Standard for Rigid Organic Printed Boards, 5.3 Design Requirements for Printed Board Assembly
Electronics Forum | Tue Nov 01 12:28:36 EDT 2016 | comatose
It depends. Are you hand breaking them, rotary knife or linear knife? Hand break you want to be about 5mm (and it isn't a great practice even then) with a rotart knife you want to keep parts probably 3mm, especially capacitors. With a linear knife we
Electronics Forum | Sat Nov 05 20:23:11 EDT 2016 | sarason
Close but not to close, would have to be the spec. Or depends on your separating technology. Prerouted boards on a panel, you could go right up to the edge. V-grove you will need more distance, maybe 2mm's or more. The distance from the panel edge to
Electronics Forum | Thu Feb 12 08:35:22 EST 2015 | davef
Solder mask is intended to protect the traces from the soldering process. That's it. [Tried to upload a picture. It's broken.]
Electronics Forum | Wed Feb 11 14:55:52 EST 2015 | erezah
we received assembled PCBs with spots that look like a bleach spots all over the PS and CS . The board house said that this is normal due to flux aqueous wash process. Can it cause problems (e.g. corrosion ) in the long run or cause issues when wor
Electronics Forum | Fri Feb 21 16:08:56 EST 2003 | clarkk
Hello all, We use pressurized air from a blower to blow off excess water from our pcb assemblies after wash. I'm concerned that this could potentially cause esd damage to sensitive assemblies. Is anyone aware of a device that can correctly ionize the
Electronics Forum | Mon May 09 11:29:05 EDT 2016 | jpal
I wanted to bump this up. I am having the same problems. I cannot convince folks it is a solder mask issue and not our process issue, even though it shows up after wave and wash. I can heat the boards and even send them back through the wave preheate
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
