Electronics Forum | Thu Feb 21 12:04:32 EST 2008 | pms
That is a correct assumption Doug.
Electronics Forum | Fri Feb 22 16:49:44 EST 2008 | pms
Steve, Trying to keep wave solder from coming up the via' from the bottom and adhering to the via's and via's pads during wave. We use WS flux thru-out the whole process. I have been concerned about possible flux intrapment in the via's. That's a g
Electronics Forum | Thu Mar 13 14:20:38 EDT 2008 | pms
Ditto. CircuitCam. http://www.aiscorp.com/ good stuff. pricey.
Electronics Forum | Thu Mar 13 15:43:47 EDT 2008 | pms
IPC design standards ??? hahahahahahahahahahaha !!!!!! 99% of our customers could care less, let alone WHAT IPC design standards are, and WHY. Tell a design engineer ? hahahahahahahaha !!!! You'll might bruise there fragile little ego.... and.
Electronics Forum | Tue Jun 03 17:53:21 EDT 2008 | pms
Anyone out there using this system ? We have been using the older DEK Vectra system. I don't like it, never did, but do like the small storage footprint, and are stencil supplier is showing signs that this system is gonna be obselete in the near fut
Electronics Forum | Wed Jun 18 15:38:15 EDT 2008 | pms
Ummmmmmmm. What's an Othello scope ?? Not that it matters.......
Electronics Forum | Thu Aug 14 18:13:21 EDT 2008 | pms
See them funky via pads ?? What's your opinions ? Junk or acceptable ?? Anyone know of an IPC manual that has pics and standards of defective and acceptable PCB's ?? Thanks
Electronics Forum | Thu Aug 21 12:06:17 EDT 2008 | pms
Thanks for your replies. The problems do not appear on the complete lot of PCB's. I don't know the percentage at this point. I agree. It also appears to me that these PCB's are over-etched. The PCB rep say's "Yea, there's a few boards that have
Electronics Forum | Mon Nov 17 12:52:12 EST 2008 | pms
That's what I was wondering too.... Just what the hell is going on here !!
Electronics Forum | Tue Dec 09 14:03:05 EST 2008 | pms
Steve, We use stencils for applying adhesives to PCB's, with our DEK Proflow system. Works well for us. Once in a while, we have to manually add adhesive to a specific location depending on the component height. Vary rare though. You shouldn't have