Electronics Forum | Thu Jan 19 08:11:27 EST 2023 | eurolan
Hello, Do you have information about the part number (if any) and/or where we could buy one? Thanks!
Electronics Forum | Thu Feb 22 13:50:18 EST 2024 | erikfriesen
Thank you, there are a few more things in that service manual than I have. Really what I was looking for, and didn't find, is there any type of comp table for the ballscrew on these machines?
Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Wed Jan 31 14:58:13 EST 2007 | pr
Is it the same nozzle every time? I would check that the shaft is hitting dead center (it could be binding)on the nozzles (especially if it only happens on 1 nozzle). Also check the rollers on the shaft (that hold the nozzle) and make sure they line
Electronics Forum | Thu Feb 22 11:15:01 EST 2024 | eurolan
I am not sure exactly which manuals you mean. Here are the ones I have as files: https://www.eurolan.net/datasheets/cp45fvneo/ If I could somehow help you let me know. We have such a machine for over 10years.
Electronics Forum | Thu Feb 22 11:15:29 EST 2024 | eurolan
I am not sure exactly which manuals you mean. Here are the ones I have as files: https://www.eurolan.net/datasheets/cp45fvneo/ If I could somehow help you let me know. We have such a machine for over 10years.
Electronics Forum | Mon Jun 19 11:16:22 EDT 2023 | eurolan
Hi guys, we managed to fix it. This tool turned out to be impossible to find. What we did is mount the motor, mark the timing belt's position and loosen the screws that attach the timing belt to the head. This way we were able to move the position of
Electronics Forum | Sat Sep 02 15:54:46 EDT 2023 | mekmat544
Hello, I would like to ask you for help. We have problem with our Selective Solder System SEHO PowerSelective. Problem is, that Z axis is decreasing. When we start soldering, height of Z axis is correct but after each solder cycle, there is decreasin
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Fri Feb 07 13:17:32 EST 2020 | bk
I am assuming you are initializing each motor individually through the service program. The z motor theta is hard to see so I put a mark on it with a colored marker so you can watch if the midas tool nozzle is actually turning or not. You should be a