Electronics Forum | Tue Sep 25 05:58:16 EDT 2012 | bobpan
I believe the Led's should flash 3 times when the card is booting up/ powering up normally. There was no board troubleshooting back in the day and we just replaced the card. Make sure the metal cover is grounded to the machine.....this sometimes caus
Electronics Forum | Fri Jun 28 09:48:32 EDT 2013 | island2013
Hi Dennis, Did you find your Aligners? We have this part in stock. Visit our Spare parts inventory at http://www.islandsmt.com or give us a call.
Electronics Forum | Wed Oct 23 10:10:39 EDT 2013 | cano1912
Ryan, found the aligners form a company here in Florida called Island SMT. They carry a lot of spare parts for different machines.
Electronics Forum | Thu May 26 15:16:28 EDT 2016 | bobpan
oh ya....i forgot....to verify this....turn off all the extents for the parts and just pick them and place them....if they are very close to where they should be then it is the quad align causing the problem....this is how you can verify it. Copy the
Electronics Forum | Fri Mar 11 14:30:03 EST 2005 | ???
i agree with changing the head board if the ribbon cables have been changed. I would also check the quad align card and make sure the cables are plugged in tight to it and to the backplane. There is a large connector on the backplane that sometimes f
Electronics Forum | Thu Dec 29 04:19:52 EST 2005 | lvqp72
We've run into a persistent QA error 99 on one of our Quad IVC's. Have checked upon all the obvious and found no bad components. Do appreciate any advice on this problem. Thanks.
Electronics Forum | Fri Jun 30 09:32:19 EDT 2006 | ppminc
Hi Andy, PPM specializes in Quad equipment. We also offer free phone-support for troubleshooting your machines. If you would like please contact us @ 603 895 5112. Shawn
Electronics Forum | Thu Sep 18 14:59:46 EDT 2008 | bobpan
Check the fuses on the quad align card. There are 2 on each card. They are surface mount type. Typically one of these have blown. Good luck
Electronics Forum | Mon Apr 13 14:48:38 EDT 2009 | bobpan
There is also a modify code that if set to 0 the quad-align will not turn on and you will have this error. It is one of the higher mod codes around 60-80......been so long i forget.... Good Luck Bob
Electronics Forum | Mon Feb 04 06:48:50 EST 2013 | bobpan
Do a function 30 on the hht and you should get a nozzle height of around 200. If its not and its around 1 you have something on the quad align lens and you will have the exact problem you are having. Hope this helps... Good luck