Electronics Forum | Fri Mar 11 09:28:34 EST 2005 | Micheal
I need help on a Quad IVC. We are having intermitant problems. What happens is it runs and then all of a sudden the Z goes down into the feeder past the limit. I have changed the Z motor, cleared the memory, and also swapped motion controller boards
Electronics Forum | Thu Mar 02 04:24:46 EST 2006 | walbone
Hi, We have recently purchased a Quad IVC 115 pick and place machine but are finding it difficult to place SOT23 and similar components. The Visual alignment system rejects the components. We have manually measured and also got the system to measure
Electronics Forum | Mon Apr 01 13:47:38 EDT 2013 | microaide
Anyone know how to use AutoProgram 5.32 for the Quad IVc assemblers? I am having all kinds of problems. I can't create a new SMD Type because the Edit menu is greyed out, so I can't select New. I can't figure out how to set up feeders and assign feed
Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Fri Mar 11 14:30:03 EST 2005 | ???
i agree with changing the head board if the ribbon cables have been changed. I would also check the quad align card and make sure the cables are plugged in tight to it and to the backplane. There is a large connector on the backplane that sometimes f
Electronics Forum | Thu Dec 29 04:19:52 EST 2005 | lvqp72
We've run into a persistent QA error 99 on one of our Quad IVC's. Have checked upon all the obvious and found no bad components. Do appreciate any advice on this problem. Thanks.
Electronics Forum | Mon Apr 13 14:48:38 EDT 2009 | bobpan
There is also a modify code that if set to 0 the quad-align will not turn on and you will have this error. It is one of the higher mod codes around 60-80......been so long i forget.... Good Luck Bob
Electronics Forum | Sat Mar 20 22:47:10 EDT 2010 | claudea2
I have recently purchased a used Quad 4C. I do not have the password for the AutoProgram. Is there a way to reset the password? Thanks Claude Arpin
Electronics Forum | Thu Mar 25 15:52:03 EDT 2010 | claudea2
Hello Paul, thank you for taking the time to answer my question. QUAD worked so I did not try the other solution. All the best Claude
