Electronics Forum | Tue May 11 12:29:47 EDT 2021 | markhoch
Yes Sir, Dual Lane. Different terminology in different parts of the world. Germans and Chinese refer to dual conveyor systems as "dual rail". I guess I've been working with them for too long. I will look into CTI, although I was hoping to find somet
Electronics Forum | Thu Feb 19 15:17:52 EST 1998 | Bipin Napal
Available immediately. Call Bipin at 416-385-0855 Make: Electrovert Model: 500 CLV Electrical: 440V, 3Phase, 60HZ Manufacturing Date: Dec 22, 1992, and upgraded in 1994 Physical Size: Length 205.5�, Width 55� Heating Zones : 10 Upper & 10 Lo
Electronics Forum | Thu Dec 20 12:27:25 EST 2001 | seand
Hello Gentlemen, Dave has a good point. Proposing to move the rails for the sake of thermal integrity doesn't seem logical to address you issue. By adding a rail set you have simply added mass (almost like big heat sinks) throughout the oven vs. w
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Thu Aug 19 13:29:43 EDT 2004 | davef
Things we�d like to have in a reflow oven are: * Small variation in temperature [+-2*C] from rail-to-rail. * Consistent temperature over time [3+ sigma]. * Thermal inertia / fast recovery to be able to respond to the effects of high mass boards. * Ra
Electronics Forum | Thu Mar 20 17:39:41 EDT 2008 | boardhouse
FSW, Another suggestions is if you have rail on your product and you are concerned about stress fracturing certain components you could add a routed slot to add relief in that area. So when you snap the rail off their would be no stress in that area
Electronics Forum | Fri Mar 08 16:30:53 EST 2013 | pctech
We have 1880 Heller about 12 years old and running like a charm everyday. I doubt that lead or non-lead operations will have anything to do with it. Do you use high temperature lubricant on edge hold chain and rail periodically? This may help to ease
Electronics Forum | Wed Mar 08 07:47:00 EST 2000 | Tenison
I would get the board vendor to put rails on the board. Tenison Stone Telex Communications
Electronics Forum | Wed Mar 08 07:47:00 EST 2000 | Tenison
I would get the board vendor to put rails on the board. Tenison Stone Telex Communications
Electronics Forum | Tue Nov 22 10:36:23 EST 2005 | maforni
Does anyone know if there are specific tools designed to remove fingers from the wave solder rails? Thanks
