Electronics Forum | Sat Sep 16 15:47:08 EDT 2006 | dekhead
95% possibility to the ballscrew... which is no ones favorite to replace. As far as the table situation now. I'm guessing that you have verified that the motor has power and the brake is not engaged. Does it still give a position error? or does it g
Electronics Forum | Sat Jan 15 16:45:46 EST 2022 | goseese
I don't seem to be finding any loose connections. I am starting to suspect perhaps the rising table driver, BGE9010C, or the Motor it's self. I just don't know how to prove one or the other. How sensitive to pressure should the table be? While jo
Electronics Forum | Fri Apr 15 15:04:02 EDT 2005 | lyrtech
Hi, Sometimes we have the following error: " TABLE BASE NOT GOOD ". In the manual, it says that we have to check the cylinder and other parts around the table. This is not very specific. Can anyone helps us with some hints? Thank you
Electronics Forum | Wed Jun 21 09:23:28 EDT 2006 | rmitchell
problem solved. Some PCB table support pins were jammed down in the table preventing the Z axis from lowering all the way. The intial error mesage was x and y servo, but the real error was the z axis overflow. Rob
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.
Electronics Forum | Tue Feb 20 09:46:08 EST 2018 | dekhead
Somewhat vague on error message; obviously has to do with RS Table travel (making sensors at anticipated time) but need to know timing of error incidents and specific error.
Electronics Forum | Tue May 22 02:27:50 EDT 2018 | bukas
there are numerous factors: -stencil age -stencil finish and thickness -stencil-board vertical alignment -board support -squeegee pressure -squeegee blade material and condition question here is did stencil changed its dimension over time? ar
Electronics Forum | Tue May 27 04:52:25 EDT 2014 | hemant_pang23
Need help to resolve the problem in DEK265 paste printer The error messages are as per following details 1. When switch on the Machine we are getting error message like " Rising Table Error" -Position error. 2.While loading the Mint we are get
Electronics Forum | Thu Feb 09 19:35:09 EST 2023 | youngbuck
Hello, We have a Dek Infinity when powering up will not initialize due to an error that says Rising Table Error (Position Error). I try to go to Diagnostics but it will not let me into anything. I press start when I'm in diagnostics and it just error
Electronics Forum | Mon Sep 20 14:15:32 EDT 2010 | dekhead
"System Suspended While Cover is Opened" indicates front or rear cover opened; not the head being raised. Therefore there is an issue with one of the cover interlocks not being made properly. Note there are 2 switches on each (NO and NC) one goes int
