Electronics Forum | Thu Jan 13 15:08:22 EST 2022 | emeto
Hello Jeff, error is telling you exactly what it is - communication problem. CAN interface is interrupted somewhere. Motors are constantly sharing position and commands with computer over CAN interface. To get this message means somewhere this circui
Electronics Forum | Sat Sep 16 15:52:32 EDT 2006 | magszoo
yes we already swapped the relays and they worked fine on the second machine. How would we verify it is the ballscrew if that is a possibility?
Electronics Forum | Thu Dec 13 05:30:29 EST 2012 | sunyb123
i have facing a problem in dek 265 horizon that rising table position error ,please help in for solving this problem
Electronics Forum | Thu Dec 22 17:59:39 EST 2022 | emanuel
Thanks Jeff, Yes, I will be glad to know which parts you replaced, at least it will give me an idea where to start looking. I also have a feeling that being the first node, the BGE9010C if not working properly may distort the CAN Bus signal. I even t
Electronics Forum | Sat Sep 16 15:47:08 EDT 2006 | dekhead
95% possibility to the ballscrew... which is no ones favorite to replace. As far as the table situation now. I'm guessing that you have verified that the motor has power and the brake is not engaged. Does it still give a position error? or does it g
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Sat Sep 16 16:02:19 EDT 2006 | dekhead
You are as close as you can be to verified... my 95% being an understatement... In a world (and a machine) where there are no absolutes... it's as good as it gets. I can't offer absolutes... without going over things that I might consider obvious bu
Electronics Forum | Tue Sep 19 09:27:55 EDT 2006 | vikkaraja
It has been a while since I worked on one of this machine. I recall having a similar problem where a timer was the root cause of my problem. There is a break timer in the back of the machine, it may not be staying latched. Swaped this device and kee
Electronics Forum | Thu Jan 13 03:56:45 EST 2022 | goseese
Hello, and thank you in advance for your help. I have just received a used DEK 03i and I am having a problem that I don't know exactly how to troubleshoot. The DEK will power up correctly and everything will initialize. When I try to set up a n
Electronics Forum | Thu Mar 28 20:06:53 EDT 2024 | cbeneat
What type head is it? Try changing the internal filters. If it is a low number head, ie: 1-4 on an 8, 1-6 on a 12 or 1-8 on a 16. These can be accessed by pushing the head to the opposite table for removal. Chapter 11, section 11-6 page 11-6.3 in mai