Electronics Forum | Tue Mar 07 10:43:27 EST 2006 | dougs
The E has a different x-y table setup, i seem to remember the CP6 having rollers and cams to control the z table height, the CP6E has a belt driven z axis. Also i think the CP6E is slightly faster, 44K cph against 40K, still just program it as a CP6
Electronics Forum | Mon Mar 27 11:03:06 EST 2006 | mapell
Tribol 1430 is the latest generation oil, 930 can't take lead free temps. Please see the following link.... http://www.castrol.com/castrol/productdetailmin.do?categoryId=82958955&contentId=6004371 If your getting alot smoke and residue, reduce the
Electronics Forum | Tue Aug 15 07:31:27 EDT 2006 | Chunks
Yes, when teaching fids and you get to the screen shows your fid (either board or stencil), hit the middle "roller button" labeled NEXT. This will toggle your bulb from regular to bright and vice/versa. If it's still very bright, the bulb itself ma
Electronics Forum | Wed Jan 31 14:58:13 EST 2007 | pr
Is it the same nozzle every time? I would check that the shaft is hitting dead center (it could be binding)on the nozzles (especially if it only happens on 1 nozzle). Also check the rollers on the shaft (that hold the nozzle) and make sure they line
Electronics Forum | Mon Oct 22 10:47:32 EDT 2007 | cyber_wolf
You absoultely must have a calibration jig. You should be able to justify this on downtime alone. Make sure your take up axles and white rollers are squeeky clean on the 12's. Also make sure that they are not running the cam speed too fast. We do no
Electronics Forum | Thu May 01 23:32:46 EDT 2014 | asajedi
I have assembled panels of 24"X9.5" LED Panels (24 strips of 10mm). I need to cut them into strips and join them together then add double sided 3M tape and spool them. How is this best accomplished. Laser Cutting, Die Cutting, Roller Cutting
Electronics Forum | Mon Jan 29 04:51:43 EST 2018 | mauricea
Dear all, Sorry for my bad english We use a MPM Momentum year 2014. This is the second time, that we have a matter with the M14 (SOLVENT ROLLER MOTOR). The 2 times, the IC U1 on the rear control module is brocken. Have you all ready this kind of ma
Electronics Forum | Wed Feb 16 23:26:48 EST 2022 | sarason
The question should be how does it ever stay on track. Replace the roller with one with closed sides and you wont have a problem. THe belts tension probably varies because of age and wear along its length, thus working for a few feet and then going o
Electronics Forum | Wed Feb 09 21:37:37 EST 2000 | Dave F
Rob: Someone's out there turning over stones, eh? Roller Tinning, Rolled Solder. In printed circuit fabrication, a surface coating of tin-lead, typically 1-2 microns thick, applied to preserve solderability. Still available from some fabricators
Electronics Forum | Mon Nov 22 10:29:18 EST 1999 | Boca
Hany, Chartrain has some good points, if you product is expensive, what does the cost of a UPS amount to? Remember, you don't want to 'back up' the heating zones, just the controller and conveyor drive system so product doesn't get stuck in the oven
