Electronics Forum | Thu Aug 12 13:18:43 EDT 2021 | conro
The HumiSeal 1B31 is actually pretty fast drying e.g. 24h @ room temperature or 30min @ 76 °C Link
Electronics Forum | Thu Mar 15 09:11:06 EDT 2007 | jdengler
Chrissie, This varies widely by paste, room temperature, and humidity. You would need to do a DOE for you exact set-up. Since you say the room is uncontrolled you need to keep in mind that time will drop as temperature goes up. Different pastes re
Electronics Forum | Wed Sep 29 03:41:32 EDT 1999 | Wolfgang Busko
| Hi All, | Any one experince BGA-chipset warp about 10-15mil after removing | from PCB? | FYI, the rework temperature for preheat was 170C from room | temperature about 30 seconds, & BGA was removed at temperature | between 190-200C. | Thankyou.
Electronics Forum | Wed Sep 29 22:50:57 EDT 1999 | Dave F
| Hi All, | Any one experince BGA-chipset warp about 10-15mil after removing | from PCB? | FYI, the rework temperature for preheat was 170C from room | temperature about 30 seconds, & BGA was removed at temperature | between 190-200C. | Thankyou.
Electronics Forum | Mon Sep 20 00:47:35 EDT 2010 | emmanueldavid
AL, Let's always remember that any Temperature controlled environment has to draw higher Time to bring the Temperature down than that is drawing for Temperature Ramp up. The best way is to keep Room Temperature in as low as possible level & open t
Electronics Forum | Tue May 15 08:40:52 EDT 2001 | Stefan Witte
The viscosity is only consistent over a small temperature range. If your room temperature has changed by a few degrees, it can make all the difference. You may have to increase the settling time. We did not check the viscosity, but measured the con
Electronics Forum | Mon May 31 19:20:50 EDT 1999 | Raeto Zryd
I have difficulty to convince my management to air-condition our manufacturing facilities. The room temperature fluxuates from 8 deg.C in the morning to 25 deg. C in the afternoon. The PCB topside temperatures in the reflow oven and wave soldering ma
Electronics Forum | Wed Sep 05 16:35:22 EDT 2012 | davef
It depends, but I'd guess that as a minimum the floor clock will start when the component returns to room temperature. It's easy to argue that the floor clock starts earlier than that!!! Probably, the floor clock starts a couple degrees lower than th
Electronics Forum | Sat Oct 20 14:24:16 EDT 2012 | davef
Not sure why you'd want to immerse an assembled board in 60-70*C IPA for an hour, but I doubt there is much published material on the topic * IPA is toxic * IPA is flammable at room temperature and heating IPA to 60-70*C only makes it more so * There
Electronics Forum | Sun Sep 04 01:59:41 EDT 2005 | smartasp
We need to dry and clean the air in our dedicated poting and conformal coating room. Can anybody help on how to go about it. The airconditions only recycle and dry until room temperature is reached and therefore have great fluctuations and unstable p