Electronics Forum | Tue Jan 14 11:02:59 EST 2003 | soupatech
I found a feeder with a 2mm pitch and was told that although it was made for the CP4, it would work with the CP3. Before we throw out a thousand bucks, has anyone had experience loading parts off of a 2mm pitch tape with the CP3? The part is a 1.6
Electronics Forum | Fri Dec 17 09:04:17 EST 2010 | wolverine
We have an older model CP40-LV that will start out the day with blurry and double vision, then after about twenty minutes of just idling, the vision slowly improved until the machine could find the board fiducials and do a passable placement job. Th
Electronics Forum | Tue Aug 01 08:57:34 EDT 2000 | CAL
We here at ACI run the CP20 or Manncorp version 2000.We are a Research and engineering Company with availablity for demonstrations. We actually love our system (Esp. the cost). Even though our machine is a low end machine we are placing advanced pack
Electronics Forum | Thu Nov 30 04:34:39 EST 2017 | robertorocco
Hi sarason The O.S. is win98 not win95. The repair function is chkdsk? Beacause the O.S. not start do you think the start chkdsk from DOS? Thanks Roberto
Electronics Forum | Thu Mar 08 16:47:26 EST 2007 | aj
A full time feeder technician - who would do such a job full time ? You would be better off implementing daily PMs for the machine operators & give them the responsibility of looking after them. Get your technician to be responsible for introducing
Electronics Forum | Tue Oct 11 18:35:59 EDT 2005 | stepheniii
How big a tank do you have at the compressor? Basically the bigger the better. You will still have the same duty cycle ratio but the compressor won't be cycling as fast. Hopefully someone here knows what a good size would be. And when you say "kic
Electronics Forum | Wed Oct 12 07:47:42 EDT 2005 | Comp tech.
Sean, I just installed a whole new comp room in our facility. 1, By kick off do you mean the comp goes into an idle mode,or shut down completely? If it just goes into an idle mode, this may be caused by your supply manifold being to small in diameter
Electronics Forum | Wed Nov 29 06:24:49 EST 2017 | sarason
It should be possible to use Ghost to copy the Harddisk nut installing it in another machine. The next trick is to repair the image by cutting the missing bit from another image made on a Virtual Machine. Be careful to use the same version that was o
Electronics Forum | Sat Jul 24 04:02:21 EDT 2004 | kent_peterson
Two ways at it.You could just put the same nozzle for both the min and max.Or you could move the feeder into a location that has similar parts using the nozzle you want. With the feeder setup it should be optimized for the least amount of nozzle ch
Electronics Forum | Sat Jul 24 04:02:18 EDT 2004 | kent_peterson
Two ways at it.You could just put the same nozzle for both the min and max.Or you could move the feeder into a location that has similar parts using the nozzle you want. With the feeder setup it should be optimized for the least amount of nozzle ch