Electronics Forum | Thu Aug 17 13:55:45 EDT 2023 | markhoch
I think we need more information. Is it moving at all? Does it move to a reference position and then stop before returning to the home position? Have you verified that all sensors are working correctly? Does the machine use stepper motors, motors & e
Electronics Forum | Thu Mar 25 07:59:57 EDT 2010 | fredc
Hello Rodrigo, My expierence is with metal cutting machine tools not Fuji placement machines. That said there are a several of areas to look at. #1.Interference on your C axis travel, look for scrape marks or something dragging on the drum. #2. Tigh
Electronics Forum | Tue Apr 04 22:19:28 EDT 2000 | Hermie
One of our Servo Amp that controls the X table motor drive went bad and was replaced with a new one. I want to play around with the one that went bad and see if I can fix it. What I need is someone to help me who had experienced with fixing the servo
Electronics Forum | Tue Nov 18 13:10:16 EST 2008 | andersenequipmentllc
I need a service manual for a Philips CSM84 type > PA1306/20. I have the PA1306/40 manual, if that > is any use to anyone. The 1306/20 was the last > model with analog servo amps and DC brush motors, > the 1306/40 was the first with AC brushless
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.
Electronics Forum | Fri May 06 16:19:40 EDT 2005 | jdengler
Does the problem happen at start-up? Does the servo amp have an error? If yes to both, could be a bad cable, or a badly tuned servo amp. If after running and the amp has an error it could still be the cable but also brings in things like a bad motor
Electronics Forum | Wed Oct 26 21:44:42 EDT 2005 | KEN
If your sure your drive lines are staying put then it must be the motor. ... odd no servo feedback alarms though. That's why I thought problem might be mechanical. Does the yv84 use servo's? IF yes, then no brushes to wrory about. Don't bother t
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Fri Apr 12 16:13:36 EDT 2002 | pjc
Dave, USI makes spray fluxers with stepper motor and servo motor controlled traverse heads that only spray on the board. Virtually no waste going up the stack. www.ultraspray.com
Electronics Forum | Wed Dec 03 23:59:31 EST 2003 | masr
Basically the problem detail is, can't read the encoder reader from the motor, I swap the servo pack, the controler cards from the pc, the output cards from the plc, the motor and still have the problem!
