73 skip component results

Electronics Forum: skip component (Page 5 of 8)

Print-Glue-Wave process

Electronics Forum | Tue Mar 11 10:19:00 EST 2003 | yngwie

We ran doublesided SMT thru Glue and Wave process before and but faced a lot of skip solder. Then the customer told us that they have similar problem when they ran the board so what they did was they print the paste-dispense the glue- place the comp

AOI: �SAKI, OMRON, MODUS,MIRTEC...?

Electronics Forum | Tue Jan 23 14:26:12 EST 2007 | CL

Hello AR, Yes we are inspecting SMT that has been wave soldered. We are not inspecting solder on through hole components. We have actually found the solder inspector works better for wave solder SMT joints than reflowed. The system is great at ident

Component usage/Reel sizes

Electronics Forum | Tue Feb 16 16:57:44 EST 2021 | spoiltforchoice

But that only applies fully if you have the nozzles inline head to match, fast turret heads prefer to hammer a single lane, at least that would be my understanding given I don't have one :(. More active reels = more to track, that may matter to some.

Re: turbulent wave restrictions

Electronics Forum | Thu May 07 21:25:56 EDT 1998 | D.Lange

| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am

Tracking SMT Attrition (Load/Unload Loss)

Electronics Forum | Thu Jul 18 11:15:27 EDT 2002 | gdstanton

Folks, I'm working on setting up an automated process which captures data on SMT component dispensing during placement. Ultimately, I'm hoping to use it to account for component attrition (load/unload losses, vision/mechanical/electrical inspection

Re: Wrong Part on Siemens

Electronics Forum | Fri Sep 24 06:38:15 EDT 1999 | pgarsoe

| | Hi All, | | | | We have 19 Siemens machine running here and lately I was assigned to come out with a proposal on the wrong part issue on Siemens Machines. All of our machines are equip with siemens part verification in which there the part barco

Optimal Speed for Universal Chip Shooters

Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick

You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i

Re: Soldering on a Ground Plane

Electronics Forum | Thu Feb 10 22:31:11 EST 2000 | Dave F

CK: If you�ve done everything under the sun process-wise at the wave: different fluxes, more heat, less heat, more contact time, and less contact time; and are running out of ideas; let me table some thoughts. � "Don�t mess with Mother Nature."