Electronics Forum | Thu Mar 12 22:32:49 EDT 2015 | louisg
Hello. I would like to know the difference (if any) between water soluble flux and test socket cleaners (e.g. for Burn-In Board test sockets). As far as I know, they both remove oxides (tin & copper) with an activator, solvent and surfactants. Tha
Electronics Forum | Mon Mar 16 08:44:42 EDT 2015 | davef
The environment of a burn-in chamber is specific. That environment has a fairly well defined affect on the metal contacts of a burn-in socket. Test socket cleaners are tailored for those specific requirements. Look at the MSDS for the WS flux and th
Electronics Forum | Mon Jun 18 21:21:25 EDT 2001 | davef
Two things: 1 A flat surface will probably help the "balls on the socket sliding off the ridge of HASL" problem, but possibly consider less risky choices for your flat surfaces that immersion silver, like: OSP, ENIG, and immersion tin. 2 Don�t throw-
Electronics Forum | Wed Jan 06 21:56:37 EST 1999 | Steve Gregory
| Youse: This is SMTnet Steve. Sacrifice the socket. By the time you finish putzing-around removing the balls to get the socket off the board, replacing the lifted pads on the board, and reballing the socket; you've burnt the $100 that the socket
Electronics Forum | Thu Jul 29 09:00:56 EDT 2004 | Bryan Sherh
Some short happens between the balls of CPU socket in my site.we decrease the reflow time from about 90sec to 50 sec and decreased the fail rate of short.but x-ray shows balls from part of the Ball array deformed....we can't further decrease the time
Electronics Forum | Fri Mar 02 15:03:39 EST 2012 | davef
21. What is the recommended way to connect the sensor? Answer (Pellistors) For VQ500 series sensors please use sockets http://www.cambion.co.uk/Catalogue/Parts/1813.htm. For other pellistors connect to header legs by soldering or mechanical methods
Electronics Forum | Tue Jan 19 18:53:42 EST 1999 | Dave
Recently, someone in the SMTNET forum had installed a Wells-CTI Z-Lok socket and found that it was one row off from the board layout pads. Was the problem due to a layout error or was the datasheet incorrect?
Electronics Forum | Thu Jan 07 03:21:13 EST 1999 | Dorothy Ho
I'm looking for some SMT test sockets. Could you tell me who can do a similar job as Ironwood Electronics, Inc.? Thanks.
Electronics Forum | Thu Jan 07 21:50:10 EST 1999 | Dave F
| I'm looking for some SMT test sockets. Could you tell me who can do a similar job as Ironwood Electronics, Inc.? Thanks. | Dorothy: Try these folks. TTYL Dave F Oztech 510.782.2654fax2656