Electronics Forum | Thu Dec 12 12:54:25 EST 2013 | jaimebc
For selective soldered components, or even hand soldered, with vertical bend components, the body of the component, in this case a resistor, is making contact with the surface of the PCB, making it impossibe to visually see the solder fillet. Or to d
Electronics Forum | Fri Dec 13 10:06:05 EST 2013 | davef
For vertical mounted, axial leaded components; the standoff from the land to the component body should be 0.4mm[0.016in] to 1.5mm[0.059in]. Right?
Electronics Forum | Sat Dec 14 02:29:52 EST 2013 | padawanlinuxero
Hello I hope this helps For a component with axial leaded - vertical The clearance of the component body or weld bead above the land is 1.00mm (0.039in) Component body must be perpendicular to the board The overall height does not exceed maxim
Electronics Forum | Tue Mar 08 02:28:03 EST 2011 | nagesh
I have an issue with PLCC Insufficient Heel solder joint fillet.The aperture dimension is : 30 x 100 mils on PCB & on stencil also(1:1 per gerber).Rohs Process. My stencil thickness is 5mils due to presence of Tssop & QFP package & i cannot increase
Electronics Forum | Fri Jul 19 13:02:01 EDT 2019 | davef
Double-check me on this, but I don't believe that A-610 [IPC-A-610] requires side fillets on QFN solder connections, because the sides of most terminations are not plated. Plating on the bottom of the termination is sufficient for a proper solder con
Electronics Forum | Wed Mar 09 16:55:02 EST 2011 | davef
We agree with the previous poster. Open-up your aperture to increase the amount of solder paste. If you don't have a heel fillet, go home.
Electronics Forum | Fri Jul 19 13:09:55 EDT 2019 | edhare
Hi, Are you referring to the condition illustrated here? ... https://www.semlab.com/qfn-solder-fillets In this case, the solder was wicked down an attached un-filled PTH via. Ed Hare SEM Lab, Inc.
Electronics Forum | Tue Mar 08 09:29:52 EST 2011 | thanh
i don't see why it was insufficient. if you want more paste, i would increase by 10-15% aperture,and maybe double prints for printer.
Electronics Forum | Fri Jul 19 01:58:30 EDT 2019 | dhanish
May I know what is the requirement for side fillet for QFN?Any information from IPC spec on QFN side fillet?We cant make the solder joint form at the side fillet.
Electronics Forum | Wed Aug 23 15:10:24 EDT 2000 | Dr. Ning-Cheng Lee
Fillet lifting is a phenomenon mostly observed at wave soldering. It is caused by mismatch in thermal expansion coefficient (TCE) between solder and parts, and aggravated by the pasty range of solder alloys. Upon cooling, the mismatch in TCE will cau