Electronics Forum | Mon Dec 16 16:35:55 EST 2002 | Jim Ferris
Randy, Steve & all, Can you guys point me in the right direction when it come to using selective wave soldering...I am trying to get in-depth information on the Pro's & Con's of having our supplier use this process for our PWA's. (I can see there ar
Electronics Forum | Thu Dec 05 11:04:27 EST 2002 | slthomas
They're IR, bottom side only. Frankly wave solder is not my forte (there are those that would claim nothing is), but I've personally been tasked with developing a process to do reliable, high volume bottom side SMT, so I'm drawing a lot from the tec
Electronics Forum | Tue Dec 03 18:31:45 EST 2002 | slthomas
At the price of Durapol we'd never get the OK to have them made. The Al fixtures are cheap and a quick turn local item. As dense as the pth parts are I also don't think there'd be any room for any holes which I really think is the answer as far a
Electronics Forum | Tue Aug 09 13:25:24 EDT 2005 | pr
From what I can gather, the annular rings are used for grounding when these boards are put in housings. A screw goes through the hole and is torqued down. If there is excess solder on the annular ring, the screw doesn't seat properly. The pallets cov
Electronics Forum | Wed Mar 12 12:28:52 EDT 2008 | operator
I recently witnessed a process in which the solder pot operator used Techspray WSOL water soluble masking to cover the areas around a connector that was to be soldered on the solder pot. He did not wait for the WSOL to cure. He soldered immediately.
Electronics Forum | Wed Mar 12 16:20:51 EDT 2008 | hussman
Poor training. Don't blame the operator, he was either shown this or left to his own devices. Be the better man and provide him a better process. Regular old peelabale solder mask would be a start.
Electronics Forum | Fri Mar 14 11:18:29 EDT 2008 | operator
The way it works is the liquid solder immediatley cures (or should I say burns) the WSOL where ever it touches it. This hardens and keeps it in place and protects whatever is under it. Some of the WSOL falls of in the pot. I am suprised that the burn
Electronics Forum | Thu Nov 01 10:57:34 EDT 2012 | kris1128
Has anyone heard whether the elevation of a plant can effect solder joint formation? One plant at sea level, one at 7,000 feet elevation... same equipment and profiles, big voiding defects at higher elevation. I did a search and found no similar post
Electronics Forum | Tue Feb 29 10:14:02 EST 2000 | Robert Hartmann
My company is just getting into the flip chip packaging arena. We are putting in a prototype/small volume wire bond PBGA line. We have some questions with regard to choosing solder balls and cleaning of flux. 1) Is there a formula for the shrink
Electronics Forum | Tue Feb 29 10:14:02 EST 2000 | Robert Hartmann
My company is just getting into the flip chip packaging arena. We are putting in a prototype/small volume wire bond PBGA line. We have some questions with regard to choosing solder balls and cleaning of flux. 1) Is there a formula for the shrink