Electronics Forum | Thu Jan 22 16:57:26 EST 2004 | davef
A "boffin"!!! How nice to have one of those aboard. Welcome.
Electronics Forum | Wed Jan 28 08:33:24 EST 2004 | Chava
I would like a copy of your document please
Electronics Forum | Thu Aug 05 05:00:34 EDT 2004 | Bryan
In my normal Pb process,we 've a station names "Remove the solder balls and clean the board",I think we'll also have such a station in our Pb-free process. Bryan
Electronics Forum | Thu Aug 01 13:28:21 EDT 2019 | solderingpro
JBC is a great station (no doubt) - I've had the opportunity to use both. I suppose it depends on who is flipping the bill. Performance wise, the QUICK TS Series is nearly identical to the JBC Station and consumables are a fraction of the cost. Ch
Electronics Forum | Sun Aug 07 13:12:45 EDT 2005 | Patty Chonis
Hello We sell soldering stations that can heat up to 200 celcius in less then 20 seconds. The temperature settings are variable and can be pre-programmed. The stations are very competitively priced and can handle home soldering applications. Please
Electronics Forum | Fri May 11 16:06:49 EDT 2001 | Charlie
How to solder one zero ohm 0805 resistor to a PCB after it is mounted in it's plastic. The Panasonic "Soft Beam" would do it if money were not a factor. Is there a similar type of soldering station out there that may just bolt to an existing conveyor
Electronics Forum | Mon Nov 17 09:47:25 EST 2008 | cisridn
I would not recommend doing BGA soldering with only a hot air gun. I have done it in the past, but the boards would eventually come back from the field because the solder joints did not form correctly and the BGA would have to be reworked again. I
Electronics Forum | Sat Apr 19 12:00:07 EDT 2003 | modeltech
I am completely new to SMT design and for my next project I plan to use SMT for the first time. Since production volumes of the PCB's will be low, hand soldering is definitely an option, and will be necessary for my prototype PCB assembly. My proble
Electronics Forum | Wed Apr 13 12:10:47 EDT 2022 | winston_one
Hello! We have a strange effect. Some pads of big trough-hole DDR slot just dessapear. Initialy it was soldered with selective soldering process (leaded, 290 degrees, ImSn finish, very short storage). Then some connectors with poor barrel fill we hav
Electronics Forum | Fri Aug 02 13:24:45 EDT 2019 | pace_worldwide
Unlike Solderpro, I'll admit I'm just a bit biased towards PACE's new ADS200 High Powered Professional Soldering Station. Up to 120 Watts of pure power in an inexpensive, all metal package ($239 in the US), as powerful as a Metcal, JBC and Hakko, yet
.gif)
