Electronics Forum | Tue Mar 07 17:00:39 EST 2023 | proceng1
Prior to the Generators, we bought tanks of N2. As long as you have an air compressor that can supply the generator, it's pretty much maintenance free. You change filters every year. In almost 15 years, other than changing filters, we've had to r
Electronics Forum | Tue Jun 08 08:40:37 EDT 1999 | Wister
Hi,my master How to iron out such soldering bridge with below conditions: 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB 3.using spraying fluxer and no-clean fl
Electronics Forum | Tue Jun 08 08:38:15 EDT 1999 | Wister
Hi,my master How to iron out such soldering bridge with below conditions: 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB 3.using spraying fluxer and no-clean fl
Electronics Forum | Tue Jun 08 12:49:41 EDT 1999 | Dave F
| Hi,my master | How to iron out such soldering bridge with below conditions: | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | 3.using spraying fluxer and n
Electronics Forum | Tue Jun 08 13:06:53 EDT 1999 | Kevin Hussey
| | Hi,my master | | How to iron out such soldering bridge with below conditions: | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | 3.using spraying fl
Electronics Forum | Tue Jun 08 17:52:53 EDT 1999 | Chrys Shea
| | | Hi,my master | | | How to iron out such soldering bridge with below conditions: | | | 1.The component(Harness)lead pitch is 2.0mm,the lead length is 3.2mm. | | | 2.PCB width is 1.6mm.Pad size is 1.65mm.Its a single copper PCB | | | 3.using s
Electronics Forum | Fri Apr 05 15:25:14 EST 2002 | davef
Spray fluxers: Where does the excess flux [that does not glomb on the board] go after being sprayed at the board? How do various spray fluxers [wave solder machines] route �used flux� differently?
Electronics Forum | Wed May 19 15:23:07 EDT 1999 | Justin Medernach
Hi All, I'm getting an Electrovert Wave. It's the replacement for the Econopak. I can't remember the name. Either way, the spray fluxer is made by USI. Does anyone have experience with this spray fluxer. Good or bad would be appreciated. Thanks
Electronics Forum | Fri Apr 12 16:13:36 EDT 2002 | pjc
Dave, USI makes spray fluxers with stepper motor and servo motor controlled traverse heads that only spray on the board. Virtually no waste going up the stack. www.ultraspray.com
Electronics Forum | Mon Aug 12 11:48:15 EDT 2002 | fastek
Phil- As Pete correctly pointed out, the early Spray Fluxers that Sensbey provided with their machines were designed by AT&T and used a similar head and nozzle design to a spray paint gun. We had good success with them.
