Electronics Forum | Tue Aug 01 16:18:59 EDT 2017 | dleeper
A quick and dirty test; Take a few inches of carrier tape, peel off the cover, gently turn it upside down and see if any of the parts stay in the tape. If they do, then you know there's an issue with the tape.
Electronics Forum | Fri Sep 01 19:54:31 EDT 2017 | tmennink
What was the outcome OrHorti after baking some? In the end we went with a different machine (Fuji NXT) which was able to get the leds out of the reel. After switching we still face a loss of about 0.5% but it is acceptable for now.
Electronics Forum | Mon Sep 04 07:09:10 EDT 2017 | ravnikar39
https://youtu.be/aMyoQK_c3hE Did you find the solution?
Electronics Forum | Wed Sep 06 14:41:02 EDT 2017 | tombstonesmt
You need to slow down the machine for starters. Try rotating your nozzle so that the touches the least amount of silicone membrane as possible.
Electronics Forum | Thu Nov 03 16:57:16 EDT 2022 | spacecase
I did clean the nozzles, but some of them are older so I will check and swap out with better looking ones. Thank you for the response, troubleshooting seems to be the main part with these things
Electronics Forum | Thu Nov 03 02:16:55 EDT 2022 | spacecase
Hey I'm having an issue with a samsung 421f component placer. The machine is fine on the first 5 boards then on the 6th or so it just throws them wherever. The problem is the smallest flat components start sticking to the nozzle even after hitting th
Electronics Forum | Tue Aug 01 11:09:44 EDT 2017 | mmjm_1099
Can you supply the following information to help with your question. 1. MFG P/N 2. Pick and Place machine being used 3. Type of nozzle and feeder being used on machine. We place a wide variety of LEDs and had similar issues and have to use custom
Electronics Forum | Tue Aug 01 15:31:12 EDT 2017 | emeto
Agreed with Thomas i increase wait time when picking and slow down Z axis. If you think it is the tape, I would suggest you send one tape to a company that puts parts in tape. let them use different pocket and compare result. If the part is sticky an
Electronics Forum | Wed Aug 02 05:27:00 EDT 2017 | tmennink
We did this test, we opened the tape and turned it upside down, indeed some leds were staying inside the tape. We will try placing them next week with a fuji NXT line. We also contacted the manufacturer, apparently heat perhaps during transport coul
Electronics Forum | Fri Aug 04 11:13:34 EDT 2017 | tombstonesmt
One tip that I found very useful in this application that hasn't been mentioned is auto pick up position teach. Our Panasonic equipment will constantly move the pick up position in regards to the center of the nozzle when scanned. On older Panasonic