Electronics Forum | Wed Jan 23 15:13:54 EST 2008 | tbkonrad
It's not the z pickup or profile bot thanks for the help, I think Mike is right. I have used these profiles hundreds if not thousands of times in the past and never had an issue. Also it was different components and different profiles almost every ti
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Mon Sep 25 12:50:42 EDT 2006 | chris g
Daxman, The diagnostic results didn't look very pretty. Especially on the vision x standard deviation. Any time there is an asterisk, that is a bad thing. The failure number for all axis, excetp theta, is .0002. Could need more air flow to the x
Electronics Forum | Wed Sep 25 13:25:13 EDT 2013 | nophsem
Hello bobpan: The machine is a QUAD 4C I turn on the machine and get the error: SRX AUTOBAUD Motor error #5 I removed the battery and then put it back in, the error remains. I removed the battery without put it back in...and turn on the machine,
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Tue Jul 10 11:36:22 EDT 2007 | dyoungquist
Hi SMT Frog We are using an upgraded Mydata TP9-1 system to place 0402s. We do an electrical test plus mechanical centering and use the C14 tool. A few things we have observed/learned: 1) Is the machine not picking the part up out of the tape? Po
Electronics Forum | Tue Oct 14 09:21:38 EDT 2014 | rgduval
Thanks, Tushar, we might give that a try. The only reason I'd lean away from it is because I've been able to determine that I can't get the nozzles to move down on head 2 in the manual screen (or move the theta). I may be chasing two problems, but,
Electronics Forum | Tue May 07 13:51:51 EDT 2013 | shankar2013
acceleration is set to lowest. Ribbon cables were replaced, theta motor replaced. I also see a message pop up just after F-MOT1-26/156:MOVFI: MOTOR TIMEOUT / F-AXIS-182:C-AXIS NOT properly out when expected / 25v reads 3V. Now all these messages
Electronics Forum | Fri Aug 30 15:44:51 EDT 2019 | valentink
I will try outline Theta and Z-axis servo issues, we were facing last time. Story behind. Our 750 is used seldom and last time after switching it on initialization procedure ends with T axis of right head: Servo alarm. Opening front cover of 750 two
Electronics Forum | Mon Jan 29 08:18:48 EST 2007 | mika
Hi Sami, A little more detailed information would be good,as it perhaps makes it easier for us to point you in the right direction of the root cause of your problem. And then you should fix that, rather than tweaking your programs around. 1. What typ
.gif)
