Electronics Forum | Tue Jun 30 12:48:59 EDT 1998 | Upinder Singh
Hi all . Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. I would appreciate if somebody could help me in the stated issue: I am trying to to place one thru hole 20 pin connector along with the SMT components by paste printing an
Electronics Forum | Wed Apr 23 18:06:23 EDT 2003 | jgregory
Grant, try TEKA solder-bearing connectors. They have a "brick" of solder that reflows during reflow. They work great! Jason Gregory
Electronics Forum | Mon Jul 06 13:17:50 EDT 1998 | Upinder Singh
| | Hi all . | | Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. | | I would appreciate if somebody could help me in the stated issue: | | I am trying to to place one thru hole 20 pin connector along with the SMT components by p
Electronics Forum | Tue Jun 30 18:37:19 EDT 1998 | Earl Moon
| Hi all . | Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. | I would appreciate if somebody could help me in the stated issue: | I am trying to to place one thru hole 20 pin connector along with the SMT components by paste pri
Electronics Forum | Mon Apr 21 09:01:38 EDT 2003 | russ
Wave solder - Initially high cost but after that it is relatively cheap. Selective soldering with a solder pot such as the Air-Vac PCBRM models - Much lower cost than wave but if you get the right nozzles it is a great process. Solder preforms - s
Electronics Forum | Mon Apr 21 09:28:06 EDT 2003 | Bryan
What does acrinym---BNY mean? can't you use Paste In Hole process,if the pitch is large enough?You can find imformation about PIH everywhere. we have tried PIH,selective soldering,wave soldering,and found that wave soldering get the best solder joint
Electronics Forum | Mon Apr 21 12:46:48 EDT 2003 | jonfox
It sounds as if the boards are designed in-house. Is this correct? If so, look for SMT versions of the BNC connector. I hhave used one from Johnson Components (http://www.johnsoncomponents.com) or look through http://coaxicom.com for something yo
Electronics Forum | Thu Sep 12 20:17:59 EDT 2013 | action_101
Good ole contact cs-400. I worked at two different companies that had these machines, all I believe were E's except 1 C. One place had one and the other place had 4 of them. Dont take this personally, but thank god my current employer doesn't have a
Electronics Forum | Sat Oct 30 16:53:19 EDT 1999 | jason
David I have recently taken the IPC-A-610B instructors course and according to the teacher the revised addtion is suppose to be 50 percent fill in plated thru holes
Electronics Forum | Tue Nov 02 17:52:17 EST 1999 | Dave F
Jim: Several points: 1 If you�re correct about corrosion of your component leads (which is entirely possible if the leads are steel, as you say), then the AIM 264-5 no-clean may not be aggressive enough to remove the corrosion you are seeing routin