Electronics Forum | Fri Jul 23 13:09:48 EDT 1999 | Steve
| There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not performing
Electronics Forum | Mon Jan 10 18:35:05 EST 2011 | eadthem
Ive used a Mirtec machine for 3 years MV3L with side angle inspection. Mirtec has some issues documentation, and repair plus. But there machine is impressive and the AOI software is good. We can find about 90-99.99% of all errors using just the 5
Electronics Forum | Thu Aug 31 09:13:13 EDT 2023 | tommy_magyar
Is there any outcome?
Electronics Forum | Tue Sep 17 15:47:42 EDT 2002 | stepheno
Where I worked previously we had some boards with a couple 15 mil pitch parts. The first batch we got all had undersized pads. We had lots of bridging. We had less bridging with bigger pads. The ball size in the paste makes a bigger diffence regar
Electronics Forum | Wed May 27 10:19:43 EDT 1998 | Jerry
We have no problems but orientation does matter. Orient with longest side of component body perpendicuar to wave. In other words the same preference as with through hole DIPS. Idea is the same as for through hole, that the surface tension will ten
Electronics Forum | Mon Aug 14 01:29:49 EDT 2023 | calebcsmt
I have noticed on a recent project, the QFN and SOP solder deposits do not seem very uniform and have been leaving little balls, whiskers and icicles of solder paste coming from some pads which leads to bridges. https://imgur.com/a/lqw5RF1 I have u
Electronics Forum | Mon Sep 23 01:28:13 EDT 2019 | sssamw
Cannot understood your problem very clearly, please check IPC standard on QFN and its mfg process, also check the QFN supplier's recommendation, so can minimize the bridge.
Electronics Forum | Mon Aug 14 05:45:16 EDT 2023 | dimamalin
First, this is the result of bad printer setup. Adjust knife pressure, PCB gap, separation speed, tooling, and stencil cleaning. Pay attention to the coating of contacts pad and height of solder mask of PCB.
Electronics Forum | Mon Aug 14 13:08:00 EDT 2023 | dimamalin
Similar issues arose for me in cases where the contact pads of components were located below the solder mask level. Ordering a thinner stencil might potentially solve the problem.
Electronics Forum | Mon Aug 14 13:21:48 EDT 2023 | calebcsmt
the implication being the soldermask is too thick, raising the top of the board higher than the pads themselves (eliminating gasketing)? Essentially, the board isn't perfectly planar would be the subject of cause it sounds like?
