Electronics Forum | Tue Apr 09 21:40:26 EDT 2002 | ianchan
We are a local enterprise with limited resources, just like you described, so hope this experience sharing helps : we place a production Visual Mechanical Inspection (VMI) inspector at the end of each Reflow Oven area, complete with magnify scope 30
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Wed Oct 23 13:01:11 EDT 2019 | compit
I have a single-view camera on a Topaz-X machine. When I define a connector type element - it displays messages like in attached files. If I change the type to IC - no problem. There is also no problem when "learning&quot
Electronics Forum | Sun Nov 10 05:40:27 EST 2019 | compit
It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lower
Electronics Forum | Mon Jun 30 08:55:31 EDT 2008 | davef
It will be tough to find a dimensional thickness specification for HASL. IPC-6012 Table 3-2, line "Fused tin-lead or solder coat - Coverage and Solderable" states the requirement that there has to be complete coverage of solder on the land, and it mu
Electronics Forum | Tue May 05 13:44:57 EDT 1998 | Mark Mitchell
Mr. Desrochers; Philips EMT Americas offers a three day course entitled, "Introduction to SMT Manufacturing". The course addresses all major factors that influence the automated SMT assembly process. Topics that are discussed in the course are list
Electronics Forum | Tue Aug 20 14:18:06 EDT 2002 | larryk
Kevin, I saw a few months ago in a Philips pamphet that they now have a "tray" that sits at the feeder locations for loose components or a small tape of components. I think it was for the Topaz machine.
Electronics Forum | Fri Dec 22 05:24:23 EST 2017 | protokos
Hi ii is possible to clone a hard disk, but the calibration data must be backup first. if this not can, then the machine must be calibrated.
Electronics Forum | Tue Aug 20 07:35:04 EDT 2002 | bmulcahy
Hi, I guess you a looking for a manual x-y table with a vacuum pick up such as SMT6000 from OK industries. I presume these are still being made-- We use one successfully at the end of a Mydata machine to place low volume components which we cannot j
Electronics Forum | Mon Aug 19 11:13:18 EDT 2002 | ksfacinelli
I would like to understand what different options people are using to place low volume / odd form parts. I am very familiar with the tweezers / vacuum pen method however this can be less than desirable. I am looking into a manual pick and place to
