Electronics Forum | Fri Jun 12 18:21:52 EDT 2020 | proceng1
I've had components move in the pocket and cause mis-picks. Generally, the part moves, but settles in the pocket after a moment. So I slowed down the pick up speed. It gave the part in the feeder a chance to settle before picking.
Electronics Forum | Mon Mar 09 16:27:46 EDT 2020 | oxygensmd
Sadly, without line controller software you won't be able to load jobs to your machines. Check your mails later.
Electronics Forum | Wed Mar 18 16:15:49 EDT 2020 | emeto
Katrina, if the machine will zero on its own, there is nothing wrong with machine itself. You can now look into network cards in both line computer and line PC.
Electronics Forum | Mon Apr 13 18:18:31 EDT 2020 | wbrenner
Does any one have a general cost percent going from class 2 to class 3 for the same Assembly.. Or, general up charge percent when biding class 2 vs class 3?
Electronics Forum | Mon Jun 22 01:19:40 EDT 2020 | jmelson
Thanks, I dug up the Sapphire listing and sent him a message. Thanks a lot, Jon
Electronics Forum | Fri Jul 03 12:59:00 EDT 2020 | compit
I enclose a piece of instruction - here I think the offset is set. Pages are not in turn, but you can handle it?
Electronics Forum | Sat Jul 04 04:00:09 EDT 2020 | zsoden
Thank you Michal but unfortunately the images have not come through. I have sent you an email that perhaps you can send them to?
Electronics Forum | Sun Jul 05 08:10:30 EDT 2020 | compit
I didn't get anything - send it to zaopatrzenie@compit.pl, I'll send it tomorrow.
Electronics Forum | Thu Jul 09 10:29:54 EDT 2020 | bobpan
12vdc on top pin 5vdc on bottom pin ground on second pin up from bottom. the rest are only needed for IQ function on Quad assembler. Bob
Electronics Forum | Mon Aug 03 01:49:03 EDT 2020 | kathleen123
Please try to use the steam aging tester and make a try ! When the water temp up to +100℃, Put your new model into the water tank. This +100℃ hot and steam water may remove the paste in via hole. Thank you. https://www.wewontech.com/steam-aging-