Electronics Forum | Fri Jun 16 07:32:46 EDT 2006 | slaine
I agree A UPS needs electrecity to work so it is definatly not exempt, and im sure it dosent fall into the other catagary either.
Electronics Forum | Tue Mar 01 10:50:32 EST 2005 | pr
I think the 1st option would be the best. I have found that a touch up person WILL TOUCH UP SOMETHING, regardless of the electrical needs of the board. This leads to a lot of unnecessary rework of joints. I would hope QC is tracking the defects and t
Electronics Forum | Thu Mar 03 11:49:23 EST 2005 | Rob
Doesn't that depend on your company's culture & management style? We (and I feel slightly dirty using this word)empowered our end of line inspection/touch up people & trained them to know what is good or bad - so issues can be immediately fed back,
Electronics Forum | Sun Mar 06 17:39:15 EST 2005 | Darby
1st law of Surface Mount. You WILL run out of parts on the last board going through before a long weekend. 2nd law of Surface Mount. Touchies WILL touch. I'm with Russ and Rob. Touch up is EVIL and should only be tolerated in exceptional circumst
Electronics Forum | Fri Jan 27 16:50:22 EST 2006 | patrickbruneel
GS I am not a lawyer and the European directive has a lot of grey areas. But if you look at 1.2 in the link I send you it states that when an appliance can still function when the electrical current is off this type of equipment is not covered by di
Electronics Forum | Thu Jun 15 14:42:35 EDT 2006 | Tim Austin
You wrote "The directive does not state anything about generating electricity"; actually it does do exactly that: Equipment, "which is dependent on electric current or electromagnetic fields in order to work properly, and equipment for the GENERATIO
Electronics Forum | Wed Jun 28 02:29:48 EDT 2006 | Loco
Wow, great article there mike! Thanks for digging it up for us! Kind regards, Loco.
Electronics Forum | Tue Jun 05 14:38:55 EDT 2001 | pteerink
You would be better served to check your print quality as you run. Any problems caused by dirty stencils ( plugged aps etc ) would show up right away as a defect. Search the forum for more on this subject. I seem to recall the same subject coming up
Electronics Forum | Wed Mar 02 18:46:02 EST 2005 | Austinj
The tendancy always has been "when in doubt, touch it up"... this is not the way to "verify the process" and is not the best strategy for multiple reasons (unessecary rework, additional labor costs, as well as making the solder joint more brittle, [i
Electronics Forum | Fri Mar 24 15:20:27 EST 2000 | Chris McDonald
I have recently purchased a Tape and reel machine from V-Tech. We are using Presure Sensitive tape and we are not geting good results. Anything bigger that a SOIC14/16 gives us trouble. The cover tape will pull off on the feeder and we will lose part