Electronics Forum | Tue Jun 13 22:00:10 EDT 2000 | Dave F
Suan: I'll take the "easy half" of your question I suspect you�re talking about Kleenox. It is a powder that you can sprinkle on your dross bed. Several points are: � Kleenox does not reduce dross. It reduces the amount of solder entrapped in dr
Electronics Forum | Mon May 24 10:45:04 EDT 1999 | John Thorup
| Can anyone help me with the correct baking cycle for removing moisture for PWB's. These are 10 layer double sided SMT. | | Thank You R. J. Klein Wassink in Soldering in Electronics states - 16 hours @ 105C or 40 hours @ 80C in a ventilated oven
Electronics Forum | Mon Jul 27 13:41:56 EDT 1998 | Chris Fontaine
Steve, We do a lot of hand spray conformal coating and have had much success. We have had much experience with Humiseal 1A20 Urethane. Acrylics are easier to work with but may not stand up to your environment. I don't have any experience with sili
Electronics Forum | Sat Jul 25 11:11:09 EDT 1998 | Mike Moninger
| Be consistant on: | 1 Keeping the coating material thinned. | 2 Using the same dipping motion on each board. Amen on thinning the coating, and you might also be concerned about the curing mechanism for the coating. Moisture-cured and 2 component
Electronics Forum | Fri Nov 01 09:46:25 EST 2002 | caldon
Lead Links- Only a small amount of lead can be absorbed through the skin, but nonetheless can be. Any cuts, abrasions raise the risk significantly. Also remember lead can be present on the skin and ingested, again a high degree of concern. From these
Electronics Forum | Fri Nov 22 17:55:39 EST 2002 | robertorre
Your problem may be related to different aspects. 1. Oxidation on landing pads. 2. Either high(To long over liquidous temp) or low temp. 3. Bad solder (not enough vehicles) Run this test: Set a hot plate to 220 degrees C. Make sure you have proper ve
Electronics Forum | Thu Jun 03 21:27:58 EDT 2004 | davef
We know of two "solder savers" 1 Kester Formula 5749 Solder Saver: We believe Kester Formula 5749 Solder Saver to be a new formulation of Kleenox. Kleenox works. It helps separate the solder entrapped in the dross. [One tiny warning, one chemical
Electronics Forum | Mon Aug 12 16:46:58 EDT 2019 | stephendo
"mostly an irritant" can be serious for some people. You can get other toxins from PCBs if you char them but you would have mentioned if they came out burnt. Was there any exhaust on the oven at all? I have seen it where we used a particularly stink
Electronics Forum | Mon Mar 02 13:06:36 EST 2020 | charliedci
If you add any "flux cored" wire solder to the pot make sure you have ventilation as the flux will burn off and smoke like crazy. This solder pot is like any used in a wave or selective solder, no flux. The flux is added to wire prior to di
Electronics Forum | Tue Apr 21 00:30:28 EDT 2020 | SMTA-Samy
The company I work at is deemed an essential business that supplies products that are vital to our country’s infrastructure and plays a significant role in response and recovery across all other sectors. We are responsible for the delivery of product