Electronics Forum | Tue Oct 20 10:14:59 EDT 2015 | aemery
Florin, Not sure if this will be helpful or not, but I have completed a couple of pot height retrofits for these waves and I seemed to remember that one of my clients spilled some solder and shorted out the 24vdc power supply. I am pretty sure this
Electronics Forum | Tue May 26 18:51:06 EDT 2009 | boloxis
Guys, I need to set up a new SMT line. I already got a refurb DEK 265 and Vitronics XPM3 reflow. I currently use Siemens but is getting really expensive (spare parts, service, upgrades, etc), I'm thinking Universal, Panasonic or Assembleon. Can
Electronics Forum | Tue Sep 20 04:28:31 EDT 2005 | Rob
Pyramax 150 is a low cost newer version of the Paragon 150, the Paragon is a newer version of the VIP. The VIP is great for lead free (as confirmed to us by BTU, who told us it was pointless upgrading that particular oven to a Pyramax). You may nee
Electronics Forum | Wed Jul 11 09:11:07 EDT 2012 | cbeneat
To check the airflow for your exhaust, use a manometer. Testo makes pretty good low cost models. Your machine manufacturer should be able to tell you what the requirement is or it's in the manual under setup. If it's a Vitronics Delta wave, I can
Electronics Forum | Mon Apr 09 14:51:04 EDT 2018 | justconmac
UPDATE The reason for the board count in the wave when there are no boards is due to operators leaving racks with empty PCB slots. The input feed sensor is a little bit more in the center of the conveyor whereas the output feed is a slightly closer t
Electronics Forum | Wed May 31 10:01:59 EDT 2006 | vickt
Efren, Dover Technologies is maybe the only true supplier of a whole SMT line combining DEK, Universal Instruments, Vitronics Soltec, Hover Davis and others. Based on the information you've provided you may want to consider the AdVantis or Genesis
Electronics Forum | Thu Jul 02 15:27:19 EDT 1998 | Justin Medernach
| | Looking to contact some users of Vitronics reflow ovens. | | Which model do you use? | | Overall opinion of equipment and company? | | Thanks in advance | Where in the world is Steve Dow when you need him? Steve was one of the pioneers at Vitroni
Electronics Forum | Fri Oct 29 09:45:08 EDT 2004 | pioneertechnology
In 1995 we bought 4 Vitronics U520 reflow ovens with top heat only. We ran these ovens until 2003 for both curing and lead reflow with no problems. In 1998 we bought 1 U520 top and bottom heat and one U820 top and bottom heat and once again we had
Electronics Forum | Mon Mar 11 07:58:59 EDT 2013 | cyber_wolf
So I have this issue with my 1240. During my weekly oven surveyor check I get a software alarm that says I am out of tolerance. Probe #3 which is closest to the hinge side of the oven is approx. 10 degrees hotter in zone 12 than the other 2 probes o
Electronics Forum | Thu Jul 17 10:09:06 EDT 2008 | dfhoadle
Were dealing with firmware issues for the stepper > motor, as well as communications problems with > the software. Vitronics is looking into it... > again, but even they seemed to be stumped. You > may want to ask your rep about it. Our machine i